Related papers: Demonstration of Thermal Images Captured by a Back…
The IR response of a backside illuminated type Yttrium Barium Copper Oxide (YBCO) transition-edge bolometer (TEB) in a free-membrane configuration is measured and analyzed. The analysis is based on a comprehensive equivalent circuit model…
To measure low-temperature thermal fields, we have developed a single-element cooled thermal imaging camera for a spectral range of 8{\div}14 {\mu}m with an internal shutter for radiometric calibration. To improve the accuracy of measuring…
Detection of infrared (IR) photons in a room-temperature IR camera is carried out by a two-dimensional array of microbolometer pixels which exhibit temperature-sensitive resistivity. When IR light coming from the far-field is focused onto…
We report on the temperature-dependent optical response of thin films of YBa2Cu3O7-{\delta} (YBCO) in the visible spectral range under cryogenic conditions. Specifically, we observe an increase in transmittance near the superconducting…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
We demonstrate thin-film metamaterials with resonances in the mid-infrared wavelength range. Our structures are numerically modeled and experimentally characterized by reflection and angularly-resolved thermal emission spectroscopy. We…
Infrared (IR) radiation detectors are used in numerous applications from thermal imaging to spectroscopic gas sensing. Obtaining high speed and sensitivity, low-power operation and cost-effectiveness with a single technology remains to be a…
Measuring temperature fields in semi-transparent media requires the knowledge of material thermo-optic properties. While the current techniques are well established for isothermal thin films, they remain unexplored for thick media where…
We describe the design, fabrication, and validation of a cryogenically-compatible quasioptical thermal source designed to be used for characterization of detector arrays. The source is constructed using a graphite-loaded epoxy mixture that…
Superconducting transition temperatures Tc of the YBCO film surface and of the YBCO film/substrate interface were measured inductively. It was observed that the interface- Tc is always higher then the surface - Tc. However deposition of…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
Scanning transmission x-ray microscopy has been used to image electric currents in superconducting films at temperatures down to 20 K. The magnetic stray field of supercurrents in a thin YBaCuO film is mapped into a soft-magnetic coating of…
We present the technical details of a broadband microwave spectrometer for measuring the complex conductance of thin films covering the range from 50 MHz up to 16 GHz in the temperature range 300 mK to 6 K and at applied magnetic fields up…
High-speed thermal imaging in the long-wave infrared (LWIR) is critical for applications from autonomous navigation to medical screening, yet existing uncooled detectors are fundamentally constrained. Resistive bolometers are limited by…
On-chip photodetectors are essential components in optical communications as they convert light into an electrical signal. Photobolometers are type of photodetector that functions through a resistance change caused by electronic temperature…
In electrically substituted radiometers, the ultra low noise control of the temperature is required. In this framework, we present results dedicated to the temperature regulation of copper plates, 3 cm diameter and 1 mm thick, using…
Long-wave infrared radiation captured by a thermal camera includes (a) emission from an object governed by its temperature and emissivity, and (b) reflected radiation from the surrounding environment. Separating these components is a…
Underexposure regions are vital to construct a complete perception of the surroundings for safe autonomous driving. The availability of thermal cameras has provided an essential alternate to explore regions where other optical sensors lack…
We report on a photo-induced transient state of YBa2Cu2O6+x in which transport perpendicular to the Cu-O planes becomes highly coherent. This effect is achieved by excitation with mid-infrared optical pulses, tuned to the resonant frequency…
Thermal radiation is the dominant heat loss mechanism for receiver units on a parabolic solar collector plant at high temperatures. Reduction of these losses is traditionally achieved through the use of an optically selective coating on the…