Related papers: Blind Modulo Analog-to-Digital Conversion
Analog multiplexing appears to be a promising solution for modern transmitters, where speed is the primary limitation. The objective is the development of a low-cost solution to compare different digital to analog (DAC) schemes. In…
Analog-to-digital converters (ADCs) stand for a significant part of the total power consumption in a massive MIMO base station. One-bit ADCs are one way to reduce power consumption. This paper presents an analysis of the spectral efficiency…
Next generation wireless systems will need higher spectral efficiency as the expected traffic volumes per unit bandwidth and dimension will inevitably grow. As a consequence, it is necessary to design coding schemes with performances close…
Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…
In this paper, an on-chip photonic sampled and quantized analog-to-digital converter (ADC) on thin-film lithium niobate platform is experimentally demonstrated. Using two phase modulators as a sampler and a 5$\times$5 multimode interference…
In this letter, we derive an approximate analytical expression for the uplink achievable rate of a massive multi-input multi-output (MIMO) antenna system when finite precision analog-digital converters (ADCs) and the common maximal ratio…
In this paper, we study the performance of blind adaptive beamforming algorithms for smart antennas in realistic environments. A constrained constant modulus (CCM) design criterion is described and used for deriving a recursive least…
Shannon's sampling theorem provides a link between the continuous and the discrete realms stating that bandlimited signals are uniquely determined by its values on a discrete set. This theorem is realized in practice using so called…
Millimeter wave systems suffer from high power consumption and are constrained to use low resolution quantizers --digital to analog and analog to digital converters (DACs and ADCs). However, low resolution quantization leads to reduced data…
The signal bandwidth of Digital to Analog Converters based on Sigma Delta Modulation is limited by speed constrains. Time-Interleaving allows coping with complexity vs. speed by replacing the original architecture by M parallel paths. These…
Conventional digitization based on the Shannon-Nyquist method, implemented via analog-to-digital converters (ADCs), faces fundamental limitations. High-dynamic-range (HDR) signals often get clipped or saturated in practice. Given a fixed…
With bandwidths on the order of a gigahertz in emerging wireless systems, high-resolution analog-to-digital convertors (ADCs) become a power consumption bottleneck. One solution is to employ low resolution one-bit ADCs. In this paper, we…
Obtaining digital representations of multivariate continuous-time (CT) signals is a challenge encountered in many signal processing systems. In practice, these signals are often acquired to extract some underlying information, i.e., for a…
This letter considers the architecture of distributed antenna system, which is made up of a massive number of single-antenna remote radio heads (RRHs), some with full-resolution but others with low-resolution analog-to-digital converter…
Unlimited sampling provides an acquisition scheme for high dynamic range signals by folding the signal into the dynamic range of the analog-to-digital converter (ADC) using modulo non-linearity prior to sampling to prevent saturation.…
Beamforming techniques utilized either at the transmitter or the receiver terminals have achieved superior quality-of-service performances from both the multi-antenna wireless communications systems, communications intelligence and radar…
In this project, we wanted to discover an analog topology that could effectively convert amplitude-modulated (AM) signals to frequency-modulated (FM) signals, while also ensuring that both sets of signals were within their respective radio…
Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…
Recently, multi-user multiple input multiple output (MU-MIMO) systems with low-resolution digital-to-analog converters (DACs) has received considerable attention, owing to the capability of dramatically reducing the hardware cost. Besides,…