Related papers: Multiscale ultrafast laser texturing of marble for…
Is there a low-density region ('gap') between water and a hydrophobic surface? Previous X-ray/neutron reflectivity results have been inconsistent because the effect (if any) is sub-resolution for the surfaces studied. We have used X-ray…
Both the shape of individual particles and their surface properties contribute to the strength of a granular material under shear. Here we show the degree to which these two aspects can be intertwined. In experiments on assemblies of 3D…
To understand the complex interplay of topography and surface chemistry in wetting, fundamental studies investigating both parameters are needed. Due to the sensitivity of wetting to miniscule changes in one of the parameters it is…
An enhanced geometric algorithm for automated pore-by-pore contact angle measurement from micro-CT images, is presented that achieves superior accuracy compared to existing methods through robust fluid-fluid and solid-fluid interface…
Surface topography strongly modifies adhesion of hard-material contacts, yet roughness of real surfaces typically exists over many length scales. This investigation aims to determine which scales of topography have the strongest effect on…
The physics of air-water interfaces plays a central role in modern theories of the hydrophobic effect. Implementing these theories, however, has been hampered by the difficulty of addressing fluctuations in the shape of such soft…
In this work we present results of the analysis of thermal properties of high-power laser bars obtained by spatially resolved thermoreflectance (TR) spectroscopy. Thermoreflectance is a modulation technique relying on periodic facet…
Liquid marbles refer to liquid droplets that are covered with a layer of non-wetting particles. They are observed in nature and have practical significance. However, a generalized framework for analyzing liquid marbles as they inflate or…
UV laser irradiation (lambda = 193 nm), below and above damage thresholds, is used to both alter and pattern the surface properties of borosilicate slides to tune and control the contact angle of a water drop over the surface. Large…
We consider theoretically the Cassie-Baxter and Wenzel states describing the wetting contact angles for rough substrates. More precisely, we consider different types of periodic geometries such as square protrusions and disks in 2D, grooves…
This contribution reports for the first time on fabrication and investigation of wetting properties of structured surfaces containing lamellae with an exceptionally high aspect ratio - height/width ratio demonstrated of 57:1. The lamellar…
We demonstrate the potential of X-ray free-electron lasers (XFEL) to advancethe understanding of complex plasma dynamics by allowing for the first time nanometer and femtosecond resolution at the same time in plasma diagnostics. Plasma…
Adsorption of small amphiphilic molecules occurs in various biological and technological processes, sometimes desired, the other times unwanted (e.g., contamination). Surface-active molecules preferentially bind to interfaces and affect…
Polymer coatings on cellulosic fibres are widely used to enhance the natural fibre properties by improving, for example, the hydrophobicity and wet strength. Here, we investigate the effects of a terpolymer P(S-co-MABP-co-PyMA) coating on…
This work focuses on the effect of soaking time on the microstructure during ultrafast heat treatment of a 50% cold rolled low carbon steel with initial ferritic-pearlitic microstructure. Dilatometry analysis was used to estimate the effect…
The wetting properties of graphene have proven controversial and difficult to assess. The presence of a graphene layer on top of a substrate does not significantly change the wetting properties of the solid substrate, suggesting that a…
The effect of ultrashort laser-induced morphological changes upon irradiation of silicon with double pulse sequences is investigated under conditions that lead to mass removal. The temporal delay between twelve double and equal-energy…
Laser surface remelting can be used to manipulate the microstructure of cast material. Here, we present a detailed analysis of the microstructure of Fe$_2$VAl following laser surface remelting. Within the melt pool, elongated grains grow…
Understanding how water wets graphene is critical for predicting and controlling its behaviour in nanofluidic, sensing, and energy applications. A key measure of wetting is the contact angle made by a liquid droplet against the surface, yet…
The exciting properties of micro- and nano-patterned surfaces found in natural species hide a virtually endless potential of technological ideas, opening new opportunities for innovation and exploitation in materials science and…