Related papers: Multi-Frequency Wireless Channel Measurements and …
This paper contains measured data and empirical models for 2.5 & 60 GHz in-building propagation path loss and multipath delay spread. Path loss measurements were recorded using a broadband sliding correlator channel sounder which recorded…
This paper presents detailed radio propagation measurements for an indoor factory (InF) environment at 6.75 GHz and 16.95 GHz using a 1 GHz bandwidth channel sounder. Conducted at the NYU MakerSpace in the NYU Tandon School of Engineering…
New spectrum allocations in the 4--8 GHz FR1(C) and 7--24 GHz FR3 mid-band frequency spectrum are being considered for 5G/6G cellular deployments. This paper presents results from the world's first comprehensive indoor hotspot (InH)…
In-vehicle wireless networks are crucial for advancing smart transportation systems and enhancing interaction among vehicles and their occupants. However, there are limited studies in the current state of the art that investigate the…
This letter provides a comparison of indoor radio propagation measurements and corresponding channel statistics at 28, 73, and 140 GHz, based on extensive measurements from 2014-2020 in an indoor office environment. Side-by-side comparisons…
Evaluating a building's wireless performance during the building design process is a new paradigm for wireless communications and building design. This paper proposes the earliest building wireless performance (BWP) evaluation theory…
The growing demand for higher data rates and expanded bandwidth is driving the exploration of new frequency ranges, including the upper mid-band spectrum (6-24 GHz), which is a promising candidate for future Frequency Range 3 (FR3)…
This paper presents comprehensive findings on the characterization of Indoor Hotspot channel parameters, derived from an extensive experimental campaign conducted at 6.9, 8.3, and 14.5 GHz in a commercial office building. Extensive…
Accurate channel modeling is essential for realizing the potential of terahertz (THz) communications in 6G indoor networks, where existing models struggle with severe frequency selectivity and multipath effects. We propose a physically…
Millimeter-wave (mmWave) and Terahertz (THz) will be used in the sixth-generation (6G) wireless systems, especially for indoor scenarios. This paper presents an indoor three-dimensional (3-D) statistical channel model for mmWave and sub-THz…
Adequate coverage with high gain antennas is key to realizing the full promise of the bandwidth available at mm/cm wave bands. We report extensive indoor measurements at 28 GHz (1000 links, 9.9 million individual power measurements, 10…
It is becoming clear that 5G wireless systems will encompass frequencies from around 500 MHz all the way to around 100 GHz. To adequately assess the performance of 5G systems in these different bands, path loss (PL) models will need to be…
Terahertz (THz) communications are envisioned as a promising technology for sixth-generation (6G) and beyond systems, owing to its unprecedented multi-gigahertz (GHz) bandwidth. In this paper, channel measurement campaigns in indoor…
In this paper, we present new measurement results to model large-scale path loss, angular spread and channel sparsity at the sub-THz (141-145 GHz) band, for both indoor and outdoor scenarios. Extensive measurement campaigns have been…
This paper presents small-scale fading measurements for 28 GHz outdoor millimeter-wave ultrawideband channels using directional horn antennas at the transmitter and receiver. Power delay profiles were measured at half-wavelength spatial…
This paper presents large-scale path loss models based on extensive ultra-wideband millimeter-wave propagation measurements performed at 28 GHz and 73 GHz in three typical indoor office layouts -- namely: corridor, open-plan, and…
To fully exploit the millimeter-wave bands for the fifth generation cellular systems, an accurate understanding of the channel propagation characteristics is required, and hence extensive measurement campaigns in different environments are…
In this paper, an outdoor channel measurement campaign at 330-360 GHz employing a 128 * 4 virtual antenna array (VAA)-based multiple-input multiple-output (MIMO) configuration is conducted. The transmitter (Tx) and receiver (Rx) location…
Millimeter-wave (mmWave) and D Band (110--170~GHz) frequencies are poised to play a pivotal role in the advancement of sixth-generation (6G) systems and beyond, owing to their ability to enhance performance metrics such as capacity,…
The much higher frequencies in the Terahertz (THz) band prevent the effective utilization of channel models dedicated for microwave or millimeter-wave frequency bands. In this paper, a measurement campaign is conducted in an indoor corridor…