Related papers: Anomalous weak values are caused by disturbance
The average result of a weak measurement of some observable $A$ can, under post-selection of the measured quantum system, exceed the largest eigenvalue of $A$. The nature of weak measurements, as well as the presence of post-selection and…
A weak measurement performed on a pre- and post-selected quantum system can result in an average value that lies outside of the observable's spectrum. This effect, usually referred to as an "anomalous weak value", is generally believed to…
Is it possible that a measurement of a spin component of a spin-1/2 particle yields the value 100? In 1988 Aharonov, Albert and Vaidman argued that upon pre- and postselection of particular spin states, weakening the coupling of a standard…
We show that the weak value of any observable in pre- and post-selected states can be expressed as the sum of the average of the observable in the pre-selected state and an anomalous part. We argue that at a fundamental level the anomalous…
The readings of a highly inaccurate "weak" quantum meter, employed to determine the value of a dichotomous variable $S$ without destroying the interference between the alternatives,may take arbitrary values. We show that the expected values…
Weak values arise experimentally as conditioned averages of weak (noisy) observable measurements that minimally disturb an initial quantum state, and also as dynamical variables for reduced quantum state evolution even in the absence of…
A general approach to the measurement of an observable with pre- and post-selection is presented. The limit of weak measurement is studied in detail, and it is shown that the phase of the probe, including a Hamiltonian contribution to it,…
Weak measurement has been shown to play important roles in the investigation of both fundamental and practical problems. Anomalous weak values are generally believed to be observed only when post-selection is performed, i.e, only a…
Weak measurement is a standard measuring procedure with two changes: it is performed on pre- and post-selected quantum systems and the coupling to the measuring device is weakened. The outcomes of weak measurements, ``weak values'' are very…
Non-statistical weak measurements yield weak values that are outside the range of eigenvalues and are not rare, suggesting that weak values are a property of every pre-and-post-selected ensemble. They also extend the applicability and valid…
The quantum mechanical weak value $A_w=\left\langle \phi|A|\psi \right \rangle / \left\langle \phi | \psi \right\rangle$ of an observable $A$ is a measurable quantity associated with an observable $A$ and pre- and post-selected states…
We show that the phenomenon of anomalous weak values is not limited to quantum theory. In particular, we show that the same features occur in a simple model of a coin subject to a form of classical backaction with pre- and post-selection.…
We discuss two questions related to the concept of weak values as seen from the standard quantum-mechanics point of view. In the first part of the paper, we describe a scenario where unphysical results similar to those encountered in the…
The role of measurement induced disturbance in weak measurements is of central importance for the interpretation of the weak value. Uncontrolled disturbance can interfere with the postselection process and make the weak value dependent on…
Weak values are quantities accessed through quantum experiments involving weak measurements and post-selection. It has been shown that 'anomalous' weak values (those lying beyond the eigenvalue range of the corresponding operator) defy…
Various quantum measurement procedures are analyzed and it is shown that under certain conditions they yield consistently {\em weak values} which might be very different from the eigenvalues, the allowed outcomes according to the standard…
It is argued that a weak value of an observable is a robust property of a single pre- and post-selected quantum system rather than a statistical property. During an infinitesimal time a system with a given weak value affects other systems…
Many 'interesting; correlated electron materials exhibit an unusual sensitivity of measured properties to external perturbations, and in particular to imperfections in the sample being measured. It is argued that in addition to its…
Weak values are usually associated with weak measurements of an observable on a pre- and post-selected ensemble. We show that more generally, weak values are proportional to the correlation between two pointers in a successive measurement.…
Recent controversy regarding the meaning and usefulness of weak values is reviewed. It is argued that in spite of recent statistical arguments by Ferrie and Combes, experiments with anomalous weak values provide a useful amplification…