Related papers: Learning to Estimate RIS-Aided mmWave Channels
The great potentials of massive Multiple-Input Multiple-Output (MIMO) in Frequency Division Duplex (FDD) mode can be fully exploited when the downlink Channel State Information (CSI) is available at base stations. However, the accurate CSI…
Reconfigurable intelligent surfaces (RISs) are envisioned as a key enabler for next-generation wireless networks, offering programmable control over propagation environments. While extensive research focuses on planar RIS architectures,…
Reconfigurable intelligent surface (RIS) has been widely discussed as new technology to improve wireless communication performance. Based on the unique design of RIS, its elements can reflect, refract, absorb, or focus the incoming waves…
Millimeter wave (mmWave) multiple-input-multi-output (MIMO) is now a reality with great potential for further improvement. We study full-duplex transmissions as an effective way to improve mmWave MIMO systems. Compared to half-duplex…
Reconfigurable intelligent surfaces (RIS) have emerged as a promising technology for enhancing wireless communication by dynamically controlling signal propagation in the environment. However, their efficient deployment relies on accurate…
In this article, deep learning is applied to estimate the uplink channels for mixed analog-to-digital converters (ADCs) massive multiple-input multiple-output (MIMO) systems, where a portion of antennas are equipped with high-resolution…
In modern communication systems, channel state information is of paramount importance to achieve capacity. It is then crucial to accurately estimate the channel. It is possible to perform SISO-OFDM channel estimation using sparse recovery…
In massive multiple-input multiple-output (MIMO) systems, hybrid analog-digital (AD) beamforming can be used to attain a high directional gain without requiring a dedicated radio frequency (RF) chain for each antenna element, which…
Channel estimation is a difficult problem in MIMO systems. Using a physical model allows to ease the problem, injecting a priori information based on the physics of propagation. However, such models rest on simplifying assumptions and…
Reconfigurable intelligent surface (RIS) is envisioned to be a promising green technology to reduce the energy consumption and improve the coverage and spectral efficiency of massive multiple-input multiple-output (MIMO) wireless networks.…
Channel estimation poses significant challenges in millimeter-wave massive multiple-input multiple-output systems, especially when the base station has fewer radio-frequency chains than antennas. To address this challenge, one promising…
Reconfigurable intelligent surface (RIS) is very promising for wireless networks to achieve high energy efficiency, extended coverage, improved capacity, massive connectivity, etc. To unleash the full potentials of RIS-aided communications,…
Hybrid analog and digital beamforming transceivers are instrumental in addressing the challenge of expensive hardware and high training overheads in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output)…
Reconfigurable intelligent surface (RIS) has become a promising technology to improve wireless communication in recent years. It steers the incident signals to create a favorable propagation environment by controlling the reconfigurable…
In this paper, we propose a joint pilot design and channel estimation scheme based on the deep learning (DL) technique for multiuser multiple-input multiple output (MIMO) channels. To this end, we construct a pilot designer using two-layer…
Owing to the unique advantages of low cost and controllability, reconfigurable intelligent surface (RIS) is a promising candidate to address the blockage issue in millimeter wave (mmWave) communication systems, consequently has captured…
We consider multi-antenna wireless systems aided by large intelligent surfaces (LIS). LIS presents a new physical layer technology for improving coverage and energy efficiency by intelligently controlling the propagation environment. In…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…
The reconfigurable intelligent surface (RIS) is considered a crucial technology for the future of wireless communication. Recently, there has been significant interest in combining RIS with spatial modulation (SM) or space shift keying…
In this paper, we adopt a three-stage based uplink channel estimation protocol with reduced pilot overhead for an reconfigurable intelligent surface (RIS)-aided multi-user (MU) millimeter wave (mmWave) communication system, in which both…