Related papers: Resolution-Adaptive All-Digital Spatial Equalizati…
The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…
This paper considers a wideband millimeter-wave MIMO system with fully digital transceivers at both the base station and the user equipment (UE), focusing on mobile scenarios. To reduce the baseband processing burden at the UE, we propose a…
We consider the downlink of a massive multiuser (MU) multiple-input multiple-output (MIMO) system in which the base station (BS) is equipped with low-resolution digital-to-analog converters (DACs). In contrast to most existing results, we…
Millimeter-wave (mm-Wave) cellular systems are a promising option for a very high data rate communication because of the large bandwidth available at mm-Wave frequencies. Due to the large path-loss exponent in the mm-Wave range of the…
Coarse quantization at the base station (BS) of a massive multi-user (MU) multiple-input multiple-output (MIMO) wireless system promises significant power and cost savings. Coarse quantization also enables significant reductions of the raw…
Millimeter-wave (mmWave) massive multi-user multiple-input multiple-output (MU-MIMO) technology promises unprecedentedly high data rates for next-generation wireless systems. To be practically viable, mmWave massive MU-MIMO basestations…
Receivers for mmWave systems suffer from high power consumption in Analog to Digital Converters (ADC), and there is a need to compare the three major receiver architectures: Analog, Hybrid and Digital Combining (AC, HC and DC). Moreover,…
This letter considers the architecture of distributed antenna system, which is made up of a massive number of single-antenna remote radio heads (RRHs), some with full-resolution but others with low-resolution analog-to-digital converter…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Millimeter-wave (mmWave) communications have been considered as a key technology for future 5G wireless networks because of the orders-of-magnitude wider bandwidth than current cellular bands. In this paper, we consider the problem of…
In this paper, we investigate a cascaded channel estimation method for a millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) system aided by a reconfigurable intelligent surface (RIS) with the BS equipped with…
This paper focuses on channel estimation for mmWave MIMO systems with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). The channel estimation performance with 1-bit spatial sigma-delta ADCs depends on the quantization noise…
Signal processing in wireless communications, such as precoding, detection, and channel estimation, are basically about solving inverse matrix problems, which, however, are slow and inefficient in conventional digital computers, thus…
In this paper, we propose a new hybrid analog and digital combining architecture for millimeter wave (mmWave) multi-user multiple-input multiple-output (MU-MIMO) systems. The proposed structure employs antenna subset selection per radio…
Cell-Free Massive Multiple-input Multiple-output (mMIMO) consists of many access points (APs) in a coverage area that jointly serve the users. These systems can significantly reduce the interference among the users compared to conventional…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
To satisfy the capacity requirements of future mobile systems, under-utilized millimeter wave frequencies can be efficiently exploited by employing massive MIMO technology with highly directive beamforming. Hybrid analog-digital beamforming…
This paper considers a multi-user semantic and data communication (MU-SemDaCom) system, where a base station (BS) simultaneously serves users with different semantic and data tasks through a downlink multi-user multiple-input single-output…
Large-scale distributed Multiuser MIMO (MU-MIMO) is a promising wireless network architecture that combines the advantages of "massive MIMO" and "small cells." It consists of several Access Points (APs) connected to a central server via a…
Massive multiuser multiple-input multiple-output (MU-MIMO) systems are expected to be the core technology in fifth-generation wireless systems because they significantly improve spectral efficiency. However, the requirement for a large…