Related papers: Microscopic picture of paraelectric perovskites fr…
Composites of ferroelectric and paraelectric perovskites have attracted a lot of attention due to their application potential in energy storage as well as novel computing and memory devices. So far the main focus of research has been on…
Whereas low-temperature ferroelectrics have a well understood ordered spatial dipole arrangement, the fate of these dipoles in paraelectric phases remains poorly understood. Using density functional theory (DFT), we find that unlike the…
The behavior of the local mode potential energy in the unit cell of BaTiO3 is studied by effective Hamiltonian numerical simulations. The study is focused on the evolution of the potential minimum felt by the Ti ion. At the paraelectric…
We report our first-principles investigations on three polytypes of BaTiO3 (BTO): a paraelectric phase with cubic Pm-3m structure and two ferroelectric (FE) phases with tetragonal P4mm and rhombohedral R3m structures. We compared the…
We carry out a completely first-principles study of the ferroelectric phase transitions in BaTiO$_3$. Our approach takes advantage of two features of these transitions: the structural changes are small, and only low-energy distortions are…
A shell model for ferroelectric perovskites fitted to results of first-principles density functional theory (DFT) calculations is strongly affected by approximations made in the exchange-correlation functional within DFT, and in general not…
The nature of the "forbidden" local- and long-range polar order in nominally nonpolar paraelectric phases of ferroelectric materials has been an open question since the discovery of ferroelectricity in oxide perovskites (ABO3). A currently…
A second-principles effective interatomic potential is introduced for the prototypical perovskite CaTiO$_3$ (CTO), relying on a Taylor polynomial expansion of the Born-Oppenheimer energy surface around the cubic reference structure, in…
By using a symmetry motivated basis to evaluate local distortions against pair distribution function data (PDF), we show without prior bias, that the off-centre Ti displacements in the archetypal ferroelectric BaTiO3 are zone centred and…
First-principles calculations were performed to investigate the ferroelectric properties of barium titanate and bismuth ferrite, as well as phonon dispersion of BaTiO3, using density functional theory and density functional perturbation…
The ferroelectric property of BaTiO$_3$ crystal arises from the strong Pseudo Jahn-Teller (PJT) interactions between the non-degenerate ground electronic state, $^1A_{1g}$ and the degenerate $^1T_{1u}$ symmetry states through the nuclear…
Near or less than 10% Nb substitution on the Ti site in perovskite SrTiO$_3$ results in metallic behavior, in contrast to what is seen in BaTiO$_3$. Given the nearly identical structure and electron counts of the two materials, the distinct…
We demonstrate how the quantum paraelectric ground state of SrTiO$_3$ can be accessed via a microscopic $ab~initio$ approach based on density functional theory. At low temperature the quantum fluctuations are strong enough to stabilize the…
We have performed detailed first-principles calculations to determine the eigenvectors of the zone-center modes of hexagonal BaTiO3 and shown that the experimentally relevant low-energy modes (including the non-polar instability) can be…
Results from dielectric and structural measurements on epitaxial SrTiO$_3$/BaZrO$_3$ superlattices reveal properties that cannot be explained simply in terms of those measured on single films of the constituent materials. For large…
We develop a first-principles scheme to study ferroelectric phase transitions for perovskite compounds. We obtain an effective Hamiltonian which is fully specified by first-principles ultra-soft pseudopotential calculations. This approach…
We model the remarkable thin-film Ba-Ti-O structures formed by heat treatment of an initial perovskite BaTiO$_3$ thin film on a Pt(111) surface. All structures contain a rumpled Ti-O network with all Ti threefold coordinated with O, and…
We used first-principles methods to perform a systematic search for potentially-stable phases of multiferroic BiFeO3. We considered a simulation cell compatible with the atomic distortions that are most common among perovskite oxides, and…
BaTiO3 (BTO) is one of the most interesting classes of perovskite materials. The present study has been complied to explore some physical properties such as mechanical, vibrational, thermo-physical, and temperature dependent thermodynamic…
BaBiO$_3$ is a mixed-valence perovskite which escapes the metallic state through a Bi valence (and Bi-O bond) disproportionation or CDW distortion, resulting in a semiconductor with a gap of 0.8 eV at zero pressure. The evolution of…