Related papers: Developing compact tuning fork thermometers for su…
A theoretical proposal that Coulomb-coupled quantum dots can be used as quantum probes to determine the temperature of a sample (i.e., an electronic reservoir) is proposed. Through the regulation of the positive or negative voltage bias in…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
We constructed a dilution-refrigerator (DR) based ultra-low temperature scanning tunneling microscope (ULT-STM) which works at temperatures down to 30 mK, in magnetic fields up to 6 T and in ultrahigh vacuum (UHV). Besides these extreme…
A Seebeck coefficient measurement apparatus has been designed and developed, which is very effective for accurate characterization of different type of samples in a wide temperature range (80 - 650K) simultaneously covering low as well as…
We describe a new 17 T cryomagnet for neutron, x-ray or optical experiments with rapid in-situ sample change. Sample temperatures are controllable from < 2 K to 300 K in vacuum. Alternatively a room temperature bore insert can be used for…
We present an experimental setup and methodology designed to facilitate high-precision thermal measurements required for infrared medical tomography. The approach which is best suited for the study of specialized hardware phantoms comprises…
An instrument has been constructed to measure a large range of magnetostriction and thermal expansion between room temperature and 4 K in a superconductive split-coil magnet, that allows investigation in magnetic fields up to 12 T. The very…
A simple and low cost apparatus has been designed and built to measure the electrical resistivity, ($\rho$), of metal and semiconductors in 300-620 K temperature range. The present design is suitable to do measurement on rectangular bar…
Material thermal properties characterization at nanoscales remains a challenge even if progresses were done in developing specific characterization techniques like the Scanning Thermal Microscopy (SThM). In the present work, we propose a…
A thermocouple of Au-Ni with only 2.5-micrometers-wide electrodes on a 30-nm-thick Si3N4 membrane was fabricated by a simple low-resolution electron beam lithography and lift off procedure. The thermocouple is shown to be sensitive to heat…
We describe a low-cost and simple setup for hyperthermia measurements on colloidal solutions of magnetic nanoparticles (ferrofluids) with a frequency-adjustable magnetic field in the range 5-500 kHz produced by an electromagnet. By…
Magnetic anisotropy encodes key information about the free-energy landscape of magnetic materials, but its quantitative characterization often requires probes beyond conventional magnetometry. A quartz tuning-fork resonator provides direct…
Experiments performed at a temperature of a few millikelvin require effective thermalization schemes, low-pass filtering of the measurement lines and low-noise electronics. Here, we report on the modifications to a commercial dilution…
We consider the problem of estimating the temperature $ T $ of a very cold equilibrium sample. The temperature estimates are drawn from measurements performed on a quantum probe strongly coupled to it. We model this scenario by resorting to…
A dipper probe for broadband Ferromagnetic Resonance (FMR) operating from 4.2 K to room temperature is described. The apparatus is based on a 2-port transmitted microwave signal measurement with a grounded coplanar waveguide. The waveguide…
We study magnetic, transport and thermal properties of Cobalt carbide nanocomposite with a mixture of Co2C and Co3C phases in 1:1 ratio, with an average particle diameter of 40$\pm 15$ nm. We show that the behavior of the nanocomposite is…
Enabling temperature dependent experiments in Atomic Force Microscopy is of great interest to study materials and surface properties at the nanoscale. By studying Curie temperature of multiferroic materials, temperature based phase…
Thermal expansion and magnetostriction are directional dependent thermodynamic quantities. For the characterization of novel quantum phases of matter it is required to study materials under multi-extreme conditions, in particular down to…
Phase-separated magnetic fluids provide a very strong magnetic response ($\mu>25$) in a liquid state material. Even small fields can cause a notable material response, but this depends on its properties, which are often difficult to…
A Faraday force magnetometer is presented for measurements of magnetization at temperatures down to 100~mK and in magnetic fields up to 14~T. The specimen is mounted on a flexible cantilever forming a force-sensing capacitor in combination…