Related papers: Bi-static Radar Cross Section Test Method by Using…
Reverberation chambers (RCs) were recently reported as a low-cost alternative to anechoic chambers (ACs) to perform radar cross-section (RCS) pattern measurements. The method consists of using transmitting and receiving antennas pointing…
This paper presents the evaluation of the Radar Cross Section (RCS) of a metallic object by measurements accomplished within the diffuse-field environment produced by a Reverberation Chamber (RC). The method is based on the extraction of…
Radar cross section (RCS) reduction has become one of the critical research areas in recent years. The RCS of the target should be small to avoid detection. Different methods are used to reduce RCS, but the major challenge with many RCS…
The conventional readout method of the RPC detector uses two sets of orthogonal readout strips placed at the both sides of the gas gap to collect signals of opposite polarities to obtain space points. A new readout method utilizing the…
In this paper, we investigate a novel reconfigurable distributed antennas and reflecting surface (RDARS) aided multi-user massive MIMO system with imperfect CSI and propose a practical two-timescale (TTS) transceiver design to reduce the…
Reducing the in-band radar cross section (RCS) of antennas has been a widely concerned problem. However, most of works focus on RCS reduction of antenna arrays, or need to additionally increase the size of a single antenna. Therefore, this…
Bistatic radar measurements offer unique spatial diversity and enhanced target characterization capabilities, rendering them increasingly vital for contemporary sensing application research. The reliability of such measurements is…
This paper presents the design and implementation of a compact, cost-effective phased array antenna system. It is capable of real-time beam-steering for dynamic target-tracking applications. The system employs a 4$\times$4 rectangular…
A cross slotted electronic band gap (EBG) with stacked rectangular patches shorted with a shorting pin is proposed in this paper. The study is being done on how the various parameters are varied by changing the probe feed location. The…
Reconfigurable Intelligent Surfaces (RISs) are envisioned to be employed in next generation wireless networks to enhance the communication and radio localization services. In this paper, we propose novel localization and tracking algorithms…
Purpose: subject motion and static field (B$_0$) drift are known to reduce the quality of single voxel MR spectroscopy data due to incoherent averaging. Retrospective correction has previously been shown to improve data quality by adjusting…
In this study, we perform a statistical analysis of the radar cross section (RCS) for various test targets in an indoor factory at \(25\)-\(28\) GHz, with the goal of formulating parameters that may be used for target identification and…
This paper presents the design and implementation of a simple, single-layer, broadband (97%, 11.3-32.3 GHz) Radar Cross Section Reduction (RCSR) Modulated Surface (MS). It uses modulation of the edge-length of the square patch (SP)…
The authors demonstrate readout of electrically detected magnetic resonance at radio frequencies by means of an LCR tank circuit. Applied to a silicon field-effect transistor at milli-kelvin temperatures, this method shows a 25-fold…
This paper presents a novel indoor positioning approach that leverages antenna radiation pattern characteristics through Received Signal Strength Indication (RSSI) measurements in a single-antenna system. By rotating the antenna or…
Radar Cross Section measurement data is often analyzed using Inverse Synthetic Aperture Radar images. This paper compares backprojection and iterative smooth reweighted $\ell_1$-minimization as methods to analyze radar cross section…
This paper presents a reflectarray compact antenna test range (RACATR). The new range layout is designed to suppress the unwanted diffraction. A fast near field optimization method has been used to determine the phase distribution of the…
We have developed an improved method of time-resolved x-ray reflectivity (XRR) using monochromatic synchrotron radiation. Our method utilizes a polycapillary x-ray optic to create a range of incident angles and an area detector to collect…
Several projects in radioastronomy plan to use large static cylindrical reflectors with an extended lobe sampling a sector of the rotating sky. This study provides the exact mathematical expression of the transit time of a celestial object…
The basic principle of operation of silicon sensors with resistive read-out is built-in charge sharing. Resistive Silicon Detectors (RSD, also known as AC-LGAD), exploiting the signals seen on the electrodes surrounding the impact point,…