Related papers: Spacing effect on pool boiling performance of thre…
The effect of turbulence on the mass and heat transfer between small heavy inertial particles (HIP) and an embedding fluid is studied. Two effects are identified. The first effect is due to the relative velocity between the fluid and the…
Fluidized beds consist of solid particles suspended in a tube by an ascending fluid. In liquids, it is not rare that particles adhere to each other, decreasing the solid-liquid contact area and the ratio between the tube and grain…
One dozen vertically oriented thin rectangular vanes, 62 cm tall and 15.2 cm wide, were placed 27 cm from the center of heptane and ethanol pool fires in continuously fed, floor-flush pans 3.2 cm and 5.1 cm in diameter in the laboratory.…
This study seeks to understand the origins of intermittency in quantities of interest in pool boiling, such as bubble departure diameter and departure time. The intermittency of nucleation site activity due to nonuniform and unsteady…
Surface bubbles have attracted much interest in the past decades. In this article, we propose to explore the lifetime and thinning dynamics of centimetric surface bubbles. We study the impact of the bubbles size as well as that of the…
In this work we study the heat transport in inhomogeneous bubbly flow. The experiments were performed in a rectangular bubble column heated from one side wall and cooled from the other, with millimetric bubbles introduced through one half…
Over the last two decades, since explosive boiling has been widely used in industry, research on it has been increased. Thermal bubble jet printer, micro injectors and using in micro medicine for injection are some possible applications.…
This study focuses on heat and mass exchange processes in hydrate foam during its formation from methane bubbles in gas hydrate stability zone (GHSZ) of the Lake Baikal and following delivery of it in open container to the lake surface. The…
High-fidelity flow boiling simulations are conducted in a vertical minichannel with offset strip fins (OSF) using R113 as a working fluid. Finite-element code PHASTA coupled with level set method for interface capturing is employed to model…
We use Direct Numerical Simulations to study the two-dimensional flow of a rotating, half soap bubble that is heated at its equator. The heating produces buoyancy and rotation generates a Coriolis forces in the fluid. However, due to the…
Preferential concentration of inertial particles by turbulence is a well recognized phenomenon. This study investigates how this phenomenon impacts the mean heat transfer between the fluid phase and the particle phase. Using direct…
We present results on the global and local characterisation of heat transport in homogeneous bubbly flow. Experimental measurements were performed with and without the injection of $\sim 2.5$ mm diameter bubbles (corresponding to $Re_b…
One of the key observables in a gravitational wave power spectrum from a first order phase transition in the early Universe is the mean bubble spacing, which depends on the rate of nucleation of bubbles of the stable phase, as well as the…
Extensive microscopic molecular dynamics simulations have been performed to study the effects of short-chain alcohols, methanol and ethanol, on two different fully hydrated lipid bilayer systems in the fluid phase at 323 K. It is found that…
This study investigates the behavior of microbubbles generated by the local heating of an ethanol/water mixture and the surrounding flow. The mixture is photothermally heated by focusing a continuous-wave laser on a FeSi$_2$ thin film.…
We use a three dimensional hydrodynamical code to simulate the effect of energy injection on cooling flows in the intracluster medium. Specifically, we compare a simulation of a 10$^{15}$ $M_\odot$ cluster with radiative cooling only, with…
The internal flow in corrugated tubes of different helical pitch, covering from the laminar to turbulent regime, was studied in order to characterize the three-dimensional flow and the influence of corrugation geometry on pressure drop and…
The effects of insulating lids on the convection beneath were investigated experimentally using rectangular convection cells in the flux Rayleigh number range $2.3\times10^{9}\leq Ra_F \leq 1.8\times10^{11}$ and cylindrical cells in the…
The passage of single air bubbles through the horizontal interface between miscible viscoplastic and Newtonian fluids, considering various combinations of densities and viscosities for the fluid layers, is studied computationally. The…
The transient process accompanied by extreme acceleration in the conical sections of hydraulic systems (e.g., draft tube, diffuser) can induce large cavitation bubbles both at the closed ends and in the bulk liquid. The collapses of the…