Related papers: Machine Learning for Model Order Selection in MIMO…
Multi-user Orthogonal Frequency Division Multiplexing (OFDM) and Multiple Output Multiple Output (MIMO) have been widely adopted to enhance the system throughput and combat the detrimental effects of wireless channels. Recently,…
This article investigates beam alignment for multi-user millimeter wave (mmWave) massive multi-input multi-output system. Unlike the existing works using machine learning (ML), an alignment method with partial beams using ML (AMPBML) is…
To compensate the loss from outdated channel state information in wideband massive multiple-input multipleoutput (MIMO) systems, channel prediction can be performed by leveraging the temporal correlation of wireless channels. Machine…
This article presents our initial results in deep learning for channel estimation and signal detection in orthogonal frequency-division multiplexing (OFDM). OFDM has been widely adopted in wireless broadband communications to combat…
Cell-free massive multiple-input multiple-output (mMIMO) networks enhance coverage and spectral efficiency (SE) by distributing antennas across access points (APs) with phase coherence between APs. However, the use of cost-efficient local…
This paper investigates the problem of hybrid precoder and combiner design for multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems operating in millimeter-wave (mmWave) bands. We propose a novel…
In multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems, representing the whole channel only based on partial subchannels will significantly reduce the channel acquisition overhead. For such a…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems typically employ hybrid mixed signal processing to avoid expensive hardware and high training overheads. {However, the lack of fully digital beamforming at…
Channel prediction compensates for outdated channel state information in multiple-input multiple-output (MIMO) systems. Machine learning (ML) techniques have recently been implemented to design channel predictors by leveraging the temporal…
In the high-mobility scenarios of next-generation wireless communication systems (beyond 5G/6G), the performance of orthogonal frequency division multiplexing (OFDM) deteriorates drastically due to the loss of orthogonality between the…
This paper analyzes the impact of non-Gaussian multipath component (MPC) amplitude distributions on the performance of Compressed Sensing (CS) channel estimators for OFDM systems. The number of dominant MPCs that any CS algorithm needs to…
Pinching-antenna systems (PASS) have recently attracted considerable attention owing to their capability of flexibly reconfiguring large-scale wireless channels. Motivated by this potential, we investigate the issue of joint localization…
Low complexity joint estimation of synchronization impairments and channel in a single-user MIMO-OFDM system is presented in this letter. Based on a system model that takes into account the effects of synchronization impairments such as…
Spectral efficiency is a key design issue for all wireless communication systems. Orthogonal frequency division multiplexing (OFDM) is a very well-known technique for efficient data transmission over many carriers overlapped in frequency.…
The presence of rich scattering in indoor and urban radio propagation scenarios may cause a high arrival density of multipath components (MPCs). Often the MPCs arrive in clusters at the receiver, where MPCs within one cluster have similar…
The next generation wireless communication networks are required to support high-mobility scenarios, such as reliable data transmission for high-speed railways. Nevertheless, widely utilized multi-carrier modulation, the orthogonal…
Channel decoding, channel detection, channel assessment, and resource management for wireless multiple-input multiple-output (MIMO) systems are all examples of problems where machine learning (ML) can be successfully applied. In this paper,…
Distributed multiple-input multiple-output (MIMO), also known as cell-free massive MIMO, has emerged as a promising technology for sixth-generation (6G) wireless networks. This letter introduces an indoor channel measurement campaign…
Uplink sensing is still a relatively unexplored scenario in integrated sensing and communication which can be used to improve positioning and sensing estimates. We introduce a pilot-based maximum likelihood, and a maximum a posteriori…
Massive MIMO is one of the main features of 5G mobile radio systems. However, it often leads to high cost, size and power consumption. To overcome these issues, the use of constrained radio frequency (RF) frontends has been proposed, as…