Related papers: Active feedback cooling of a SiN membrane resonato…
Feedback-based control of nano- and micromechanical resonators can enable the study of macroscopic quantum phenomena and also sensitive force measurements. Here, we demonstrate the feedback cooling of a low-loss and high-stress macroscopic…
A promising route to novel quantum technologies are hybrid quantum systems, which combine the advantages of several individual quantum systems. We have realized a hybrid atomic-mechanical experiment consisting of a SiN membrane oscillator…
We have employed a feedback cooling scheme, which combines high-frequency mixing with digital signal processing. The frequency and damping rate of a 2 MHz micromechanical resonator embedded in a dc SQUID are adjusted with the feedback, and…
Preparing a massive mechanical resonator in a state with quantum limited motional energy provides a promising platform for studying fundamental physics with macroscopic systems and allows to realize a variety of applications, including…
Cooled, low-loss nanomechanical resonators offer the prospect of directly observing the quantum dynamics of mesoscopic systems. However, the present state of the art requires cooling down to the milliKelvin regime in order to observe…
Active feedback cooling of levitated dielectric particles is a pivotal technique for creating ultrasensitive sensors and probing fundamental physics. Here we demonstrate phase-adaptive feedback cooling of silica nanoparticles optically…
We apply a feedback cooling technique to simultaneously cool the three electromechanical normal modes of the ton-scale resonant-bar gravitational wave detector AURIGA. The measuring system is based on a dc Superconducting Quantum…
Measurement-based control, utilizing an active feedback loop, is a standard tool in technology. Feedback control is also emerging as a useful and fundamental tool in quantum technology and in related fundamental studies, where it can be…
Here we analyse ways to achieve deep subthreshold parametric squeezing of fluctuations beyond the $-6$~dB limit of single degree-of-freedom parametric resonators. One way of accomplishing this is via a lock-in amplifier feedback loop.…
Coherent feedback stabilises a system towards a target state without the need of a measurement, thus avoiding the quantum backaction inherent to measurements. Here, we employ optical coherent feedback to remotely cool a nanomechanical…
We apply adaptive feedback for the partial refrigeration of a mechanical resonator, i.e. with the aim to simultaneously cool the classical thermal motion of more than one vibrational degree of freedom. The feedback is obtained from a neural…
Free-standing silicon nitride (SiN) mechanical resonators are of central interests in applications such as temperature and mass sensing, and for fundamental optomechanical reasearch. Understanding thermal coupling between a membrane…
We demonstrate feedback cooling of a millimeter-scale, 40 kHz SiN membrane from room temperature to 5 mK (3000 phonons) using a Michelson interferometer, and discuss the challenges to ground state cooling without an optical cavity. This…
Macroscopic rotors are interesting model systems to test quantum theory and for quantum sensing. A promising approach for bringing these systems to the quantum regime is to combine sensitive detection with feedback cooling to reduce the…
Thermal noise is a major obstacle to observing quantum behavior in macroscopic systems. To mitigate its effect, quantum optomechanical experiments are typically performed in a cryogenic environment. However, this condition represents a…
We demonstrate 8.5 dB thermal squeezing of a membrane oscillator using the dynamical backaction effect and electrostatic feedback in an optomechanical membrane-in-the-middle setup. We show that strong squeezing can be obtained even in the…
Photo-induced forces can be used to manipulate and cool the mechanical motion of oscillators. When the oscillator is used as a force sensor, such as in atomic force microscopy, active feedback is an enticing route to enhancing measurement…
We describe an experiment in which we have used a cold damping feedback mechanism to reduce the thermal noise of a mirror around its mechanical resonance frequency. The monitoring of the brownian motion of the mirror allows to apply an…
We cool the fundamental mechanical mode of an ultrasoft silicon cantilever from a base temperature of 2.2 K to 2.9 +/- 0.3 mK using active optomechanical feedback. The lowest observed mode temperature is consistent with limits determined by…
Measurement-based control has emerged as an important technique to prepare mechanical resonators in pure quantum states for applications in quantum information processing and quantum sensing. Conventionally this has required two separate…