Related papers: Preparation and Characterization of Thin Arsenic T…
Resistive heating and mechanical rolling methods have been employed to prepare isotopically enriched thin target foils of 116Sn (~380 \mu g/cm2), 124Sn(~400 \mu g/cm2) and thicker foils of 112Sn (1.7 mg/cm2),120Sn (1.6 mg/cm2),respectively.…
In this work, a simple and efficient thin ($50- 350\mu g/cm^2$) deuterated polyethylene target preparation method is described. The method of easy removal of thin targets from casting surface without using any cryogenic freezing has been…
The direct measurement of reaction cross sections at astrophysical energies often requires the use of solid targets of known thickness, isotopic composition, and stoichiometry that are able to withstand high beam currents for extended…
A scalable line of liquid argon TPC detectors is described, based on a three dimensional cubic frame array immersed on a common liquid argon volume. The paper describes general lines, main construction criteria, crucial points, parameters…
The development of scalable techniques to make 2D material heterostructures is a major obstacle that needs to be overcome before these materials can be implemented in device technologies industrially. Electrodeposition is an industrially…
$^{72}$As is a promising positron emitter for diagnostic imaging that can be employed locally using a $^{72}$Se generator. However, current reaction pathways to $^{72}$Se have insufficient nuclear data for efficient production using…
This study presents a further step within the ongoing R&D activities for the redesign of the CERN's Antiproton Decelerator Production Target (AD-Target). A first scaled target prototype, constituted of a sliced core made of ten Ta rods -8…
This study introduces a straightforward electrode design featuring sharp edges with a curvature of a few hundred nanometers in radius, with which both ion accumulation and nanoparticle deposition can be observed under an alternating…
An extremely efficient ethanol fuel cell electrode is produced by combining the large surface area of vertically oriented and highly conductive few-layer graphene sheets with electrochemically deposited palladium nanoparticles. The…
We prepare high quality actinide targets for studies of neutron induced and charged particle induced fission. I report on our efforts to measure fragment energy loss in the target backings and to diagnose the crud problem frequently found…
The LiF target preparation on self-supporting Ag backing (LiF/Ag) is discussed in a detailed manner using vacuum evaporation process. The target thickness is measured using the energy loss of three line alpha source. 183.74 {\mu}g/cm 2…
Precise radon measurements are a requirement for various applications, ranging from radiation protection over environmental studies to material screening campaigns for rare-event searches. All of them ultimately depend on the availability…
Manganese-doped zinc sulfide nanocrystalline thin films were synthesized using a low-temperature chemical bath deposition and deposited on glass substrates for controlled durations using triethanolamine (TEA) as a complexing and capping…
A system of modular sealed gas target cells has been developed for use in electron scattering experiments at the Thomas Jefferson National Accelerator Facility (Jefferson Lab). This system was initially developed to complete the MARATHON…
A thin coating of thorium on aluminium substrates with the areal density of 110 to 130 $\mu g/cm^2$ is developed over a circular area of 22 mm diameter by using the electrodeposition method. An electrodeposition system is fabricated to…
Edge-TCT and charge collection measurements with passive test structures made in LFoundry 150 nm CMOS process on p-type substrate with initial resistivity of over 3 k$\Omega$cm are presented. Measurements were made before and after…
The T2K near-detector, ND280, employs three large argon gas TPCs (Time Projection Chambers) for particle tracking and identification. The gas inside the TPCs can be used as an active target to study the neutrino interactions in great…
A 280 ml liquid hydrogen target has been constructed and tested for the MUSE experiment at PSI to investigate the proton charge radius via simultaneous measurement of elastic muon-proton and elastic electron-proton scattering. To control…
High quality ZnO thin films were gown using the pulsed laser deposition technique on (0001) Al$_2$O$_3$ substrates in an oxidizing atmosphere, using a Zn metallic target. We varied the growth conditions such as the deposition temperature…
Over the last two decades, prototype devices for future classical and quantum computing technologies have been fabricated, by using scanning tunneling microscopy and hydrogen resist lithography to position phosphorus atoms in silicon with…