Related papers: Material survey for millimeter-wave absorber using…
Niobium nitride (NbN) is a useful material for fabricating detectors because of its high critical temperature and relatively high kinetic inductance. In particular, NbN can be used to fabricate nanowire detectors and mm-wave transmission…
An ultrabroad absorber based on double-ring-shaped titanium nitride (TiN) nanoresonators, which can work in high temperatures, is proposed and numerically studied. The absorber with some optimal parameters exhibits an averaged absorption of…
We achieve high detectivity terahertz sensing using a silicon nitride nanomechanical resonator functionalized with a metasurface absorber. High performances are achieved by striking a fine balance between the frequency stability of the…
We observe near 100 % absorption of light in intense ultrashort laser plasma interaction in a metal coated (Au on glass) sub-lambda grating structure under suitable conditions and the subsequent 'hot' electron generation from the grating…
Microwave impedance microscopy (MIM) is a near-field imaging technique that has been used to visualize the local conductivity of materials with nanoscale resolution across the GHz regime. In recent years, MIM has shown great promise for the…
Dark photons with masses in the 1-100 eV range can be produced in the Sun and subsequently absorbed in terrestrial detectors, offering a promising avenue for probing hidden-sector physics beyond the Standard Model. In this work, we develop…
Large deployable antennas with a mesh surface woven by fine metal wires are an important technology for communications satellites and space radio telescopes. However, it is difficult to make metal mesh surfaces with sufficient…
The electromagnetic properties and microwave absorption capabilities are studied in an anechoic chamber under real radar conditions for mono and bilayer composite samples consisting of a polymeric matrix and a magnetic powder filler, either…
A metamaterial composed of thin metallic strips as an efficient broadband absorber in the mid-infrared spectrum is investigated. Here the matching between dielectric and geometrical properties of the individual elements is critical to…
We present a Raman-based Distributed Temperature Sensor (RDTS) with centimetre-scale resolution for thermographic analysis of electronic circuits. Temperature is measured along a single-mode fiber routed across a custom printed circuit…
Data on thermal absorptivity and emissivity are important for calculations of heat flows in cryogenic devices. Although thermal radiative properties of materials used in cryogenics are measured, published and used for more than sixty years…
We consider the space of all causal bulk materials, 2D materials, and metamaterials for maximum near-field radiative heat transfer (RHT). Causality constrains the bandwidth over which plasmonic response can occur, explaining two key traits…
Development of novel radiation-absorbent materials and devices for millimetre and submillimetre astronomy instruments is a research area of high interest, and with substantial engineering challenges. Alongside low-profile structure and…
The absorption of electromagnetic radiation by a planar structure, consisting of a three-layer dielectric-metal-dielectric coating on a metal back-reflector is analysed. The conditions for total absorption are derived. Our analysis shows…
La$_{1.5}$Sr$_{0.5}$NiO$_4$ is well known to have a colossal dielectric constant ($\varepsilon_R>10^7$). The La$_{1.5}$Sr$_{0.5}$NiO$_4$ nanoparticle powder was prepared by a combinational method of solid state reaction and high-energy ball…
The four-level heterodyne Rydberg atom receiver has garnered significant attention in microwave detection and communication due to its high sensitivity and phase measurement capabilities. Existing theoretical studies, primarily based on…
We demonstrate three-dimensional magnetic resonance tomography with a resolution down to 5.99 +- 0.07 nm. Our measurements use lithographically fabricated microwires as a source of three-dimensional magnetic field gradients, which we use to…
Microwave power absorption by a two-layer system deposited on a metallic surface has been studied in the experimental setup emulating the response to a radar signal. Layers containing hexaferrite and iron powder in a dried paint of…
We propose a low-pretension reflective kirigami film as a material for the reflective surfaces of large deployable space reflector antennas with an operating frequency around 10 GHz. The kirigami cut pattern is based on the well-known…
We present a metamaterial that acts as a strongly resonant absorber at terahertz frequencies. Our design consists of a bilayer unit cell which allows for maximization of the absorption through independent tuning of the electrical…