Related papers: LES wall modeling for heat transfer at high speeds
The scaling argument developed by Larichev and Held (1995) for eddy amplitudes and fluxes in a horizontally homogeneous, two-layer model on an f-plane is extended to a beta-plane. In terms of the non-dimensional number x =…
Reynolds-averaged Navier-Stokes (RANS) turbulence models (such as k-\epsilon models) are still widely used for engineering applications because of their relatively simplicity and robustness. In fully developed plane channel flow (i.e. the…
Physics-based closures such as eddy-viscosity and backscattering models are widely used for large-eddy simulation (LES) of geophysical turbulence for applications including weather and climate prediction. However, these closures have…
The present research proposes a new memory-efficient method using diffusion models to inject turbulent inflow conditions into Large Eddy Simulation (LES) and Direct Numerical Simulation (DNS) for various flow problems. A guided diffusion…
For wall-bounded turbulent flows, Townsend's attached eddy hypothesis proposes that the logarithmic layer is populated by a set of energetic and geometrically self-similar eddies. These eddies scale with a single length scale, their…
A closure model is presented for large-eddy simulation (LES) based on the three-dimensional variational data assimilation algorithm. The approach aims at reconstructing high-fidelity kinetic energy spectra in coarse numerical simulations by…
Simulating turbulence is critical for many societally important applications in aerospace engineering, environmental science, the energy industry, and biomedicine. Large eddy simulation (LES) has been widely used as an alternative to direct…
A joint experimental and numerical investigation of turbulent flame front anchoring at externally heated walls is presented. The phenomenon is examined for lean hydrogen/air mixtures in a novel burner design, which comprises a cylindrical…
Motivated by the need to characterize the spatio-temporal structure of turbulence in wall-bounded flows, we study wavenumber-frequency spectra of the streamwise velocity component based on large-eddy simulation (LES) data. The LES data are…
While direct numerical simulations (DNS) are the most accurate method for studying turbulence, their large computational cost restricts their use to idealized configurations and to Reynolds numbers well below those found in practical…
We study the numerical errors of large-eddy simulation (LES) in isotropic and wall-bounded turbulence. A direct-numerical-simulation (DNS)-aided LES formulation, where the subgrid-scale (SGS) term of the LES is computed by using filtered…
Velocity and temperature distributions are both crucial for modeling compressible wall-bounded turbulent flows. The compressible law of the wall for velocity has been extensively examined through velocity transformations. However, a…
The study presents wall-modeled large-eddy simulations (LES) characterizing the flow features of a neutral atmospheric boundary layer over two urban-like roughness geometries: an array of three-dimensional square prisms and the…
The development of a wall model using machine learning methods for the large-eddy simulation (LES) of separated flows is still an unsolved problem. Our approach is to leverage the significance of separated flow data, for which existing…
In the last decade, progresses in additive manufacturing (AM) have paved the way for optimized heat exchangers, whose disruptive design will depend on predictive numerical simulations. Typical AM rough surfaces show limited resemblance to…
Accurate modeling of ice accretion is important for safe and efficient design of aircraft and wind turbine systems. Heat transfer predictions obtained from fluid flow solvers are used as input in ice accretion codes. In glaze ice…
In supersonic and hypersonic flows, the near-wall density variation due to wall cooling poses a challenge for accurately predicting the near-wall velocity and temperature profiles using classical eddy viscosity turbulence models.…
Considering structure functions of the streamwise velocity component in a framework akin to the extended self-similarity hypothesis (ESS), de Silva \textit{et al.} (\textit{J. Fluid Mech.}, vol. 823,2017, pp. 498-510) observed that…
Two-dimensional (2-D) spectra of the streamwise velocity component, measured at friction Reynolds numbers ranging from 2400 to 26000, are used to refine a model for the logarithmic region of turbulent boundary layers. Here, we focus on the…
Results of direct numerical simulations (DNS) of porous-wall turbulent flows in open channels with conjugate heat transfer are reported in this work. For the conductive porous walls considered here, the change in heat transfer is not…