Related papers: Reduction in Circulating Current with Improved Sec…
This paper proposes a node flux-linkage synchronizing control method (NFSCM) for power systems with 100% wind power generation based on a capacitor voltage balancing scheme (CVBS). Different from the conventional grid-forming controllers,…
Digital control has become increasingly widespread in modern power electronic converters. When acquiring feedback signals such as the inductor current, synchronizing the analog-to-digital converter (ADC) with the digital pulse-width…
We measure the rectified dc currents resulting when a 3-terminal semiconductor device with gate-dependent conductance is driven with an ac gate voltage. The rectified currents exhibit surprisingly complex behaviour as the dc source-drain…
As the last resort of emergency control, controlled islanding is an effective means of preventing fault-propagation and a system-wide blackout. However, conventional AC transmission lines are unavailable to be employed for power exchange…
We consider the problem of grid-forming control of power converters in low-inertia power systems. Starting from an average-switch three-phase inverter model, we draw parallels to a synchronous machine (SM) model and propose a novel…
In this paper, a non-isolated high step-up dc-dc converter is presented. The proposed converter is composed of an interleaved structure and diode-capacitor multiplier cells for interfacing low-voltage renewable energy sources to…
An increasing integration of photovoltaic units, electric vehicle chargers, heat pumps, and energy storage systems challenges low-voltage power grids and can cause voltage range violation, loss of stability, (local) overload of lines, and…
In this paper, we propose a centralized secondary control for the real-time steady-state optimization of multi-terminal HVdc grids under voltage and current limits. First, we present the dynamic models of the grid components, including the…
This paper describes a SIMO DC-DC converter capable of generating all the required voltages (buck and boost) utilizing n-type transistors for the output switches. The design incorporates only one shared bootstrap capacitor and a single pad…
In this paper, a novel model-free wide-area damping control (WADC) method is proposed, which can achieve full decoupling of modes and damp multiple critical inter-area oscillations simultaneously using grid-connected voltage source…
Hybrid AC/DC microgrids with distributed energy storage (DS) improve power reliability in remote areas. Existing power management methods either focus on steady-state power sharing or transient inertia support, but rarely combine both. They…
This paper discusses a 100 W single stage Power Factor Correction (PFC) flyback converter operating in boundary mode constant ON time methodology using a synchronous MOS-FET rectifier on the secondary side to achieve higher efficiency.…
This paper addresses the problem of output voltage regulation for multiple DC-DC converters connected to a grid, and prescribes a robust scheme for sharing power among different sources. Also it develops a method for sharing 120 Hz ripple…
In this paper we prove optimality of a certain class of Analog to Digital Converters (ADCs), which can be viewed as generalized Delta-Sigma Modulators (DSMs), with respect to a performance measure that can be characterized as the worst-case…
AC optimal transmission switching (AC-OTS) is a computationally challenging problem due to the nonconvexity and nonlinearity of AC power-flow (PF) equations coupled with a large number of binary variables. A computationally efficient…
In this work, we present a novel consensus-based secondary control scheme for current sharing and voltage balancing in DC microgrids, composed of distributed generation units, dynamic RLC lines, and nonlinear ZIE (constant impedance,…
This paper reviews commonly used three-phase isolated AC-DC converters and introduces a novel Y-configuration Active Bridge (YAB) converter for single-stage isolated AC-DC power conversion. The proposed YAB addresses the limitations of…
Integrating grid-forming converters (GFMCs) into grid-following converter (GFLC)-dominated power systems enhances the grid strength, but GFMCs' current-limiting characteristic triggers dynamic switching between constant voltage control…
The design of gate drivers is an important topic in power converter topologies that can help reduce switching losses and increase power density. Gate driving techniques that offer zero-voltage switching and/or zero current switching have…
With the increasing interest in converter-fed islanded microgrids, particularly for resilience, it is becoming more critical to understand the dynamical behavior of these systems. This paper takes a holistic view of grid-forming converters…