Related papers: Sparse Layered MIMO with Iterative Detection
Massive spatial modulation (SM)-MIMO, which employs massive low-cost antennas but few power-hungry transmit radio frequency (RF) chains at the transmitter, is recently proposed to provide both high spectrum efficiency and energy efficiency…
We propose an iterative channel estimation algorithm based on the Least Square Estimation (LSE) and Sparse Message Passing (SMP) algorithm for the Millimeter Wave (mmWave) MIMO systems. The channel coefficients of the mmWave MIMO are…
We establish area theorems for iterative detection over coded linear systems (including multiple-input multipleoutput (MIMO) channels, inter-symbol-interference (ISI) channels, and orthogonal frequency-division multiplexing (OFDM) systems).…
In this paper, we consider a multiuser massive single-input multiple-output (SIMO) enabled Industrial Internet of Things (IIoT) communication system. To reduce the latency and overhead caused by channel estimation, we assume that only the…
Low complexity joint estimation of synchronization impairments and channel in a single-user MIMO-OFDM system is presented in this letter. Based on a system model that takes into account the effects of synchronization impairments such as…
Multiple-input multiple-output has been a key technology for wireless systems for decades. For typical MIMO communication systems, antenna array elements are usually separated by half of the carrier wavelength, thus termed as conventional…
Orthogonal time frequency space (OTFS) modulation has emerged as a robust solution for high-mobility wireless communications. However, conventional detection algorithms, such as linear equalizers and message passing (MP) methods, either…
Millimeter wave multiple-input multiple-output (MIMO) communication systems must operate over sparse wireless links and will require large antenna arrays to provide high throughput. To achieve sufficient array gains, these systems must…
In this paper, we propose an enhanced leakage-based precoding scheme, i.e., layer signal to leakage plus noise ratio (layer SLNR) scheme, for multi-user multi-layer MIMO systems. Specifically, the layer SLNR scheme incorporates the MIMO…
Signal-to-leakage-and-noise ratio (SLNR) is a promising criterion for linear precoder design in multi-user (MU) multiple-input multiple-output (MIMO) systems. It decouples the precoder design problem and makes closed-form solution…
Multiple-input multiple-output (MIMO) transceiver design and probabilistic shaping (PS) are key enablers for high spectral efficiency in 6G wireless networks. This work proposes a distribution-aware MIMO transceiver optimized for PS…
Multiple-input multiple-output (MIMO) has been a key technology of wireless communications for decades. A typical MIMO system employs antenna arrays with the inter-antenna spacing being half of the signal wavelength, which we term as…
This paper investigates the robust design of symbol-level precoding (SLP) for multiuser multiple-input multiple-output (MIMO) downlink transmission with imperfect channel state information (CSI) caused by channel aging. By utilizing the a…
In this paper, we propose a novel channel estimation algorithm based on the Least Square Estimation (LSE) and Sparse Message Passing algorithm (SMP), which is of special interest for Millimeter Wave (mmWave) systems, since this algorithm…
This paper proposes spatial lattice modulation (SLM), a spatial modulation method for multipleinput-multiple-output (MIMO) systems. The key idea of SLM is to jointly exploit spatial, in-phase, and quadrature dimensions to modulate…
This article introduces an energy and spectral efficient multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) transmission scheme designed for the future sixth generation (6G) wireless communication…
This paper investigates a joint beamforming design in a multiuser multiple-input single-output (MISO) communication network aided with an intelligent reflecting surface (IRS) panel. The symbol-level precoding (SLP) is adopted to enhance the…
In this paper, we investigate symbol-level precoding (SLP) and efficient decoding techniques for downlink transmission, where we focus on scenarios where the base station (BS) transmits multiple QAM constellation streams to users equipped…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a newly introduced architecture that enables both spatial multiplexing and beamforming while facilitating highly reconfigurable hardware implementation in…
In wireless communication systems, the use of multiple antennas at both the transmitter and receiver is a widely known method for improving both reliability and data rates, as it increases the former through transmit or receive diversity…