Related papers: Elastic-brittle reinforcement of flexural structur…
Solid interfaces have intrinsic elasticity. However, in most experiments, this is obscured by bulk stresses. Through microscopic observations of the contact-line geometry of a partially wetting droplet on an anisotropically stretched…
This paper is devoted to describe the asymptotic behavior of a structure made by a thin plate and a thin rod in the framework of nonlinear elasticity. We scale the applied forces in such a way that the level of the total elastic energy…
We discuss the plastic behavior of an amorphous matrix reinforced by hard particles. A mesoscopic depinning-like model accounting for Eshelby elastic interactions is implemented. Only the effect of a plastic disorder is considered.…
We consider an elastic composite material containing particulate inclusions in a soft elastic matrix that is bounded by a rigid wall, e.g., the substrate. If such a composite serves as a soft actuator, forces are imposed on or induced…
This paper studies the aeroelasticity of a stiffened cantilever plate using composite material and novel structural layouts. A comprehensive parametric study is conducted to determine the influence of different design parameters on the…
The response of amorphous materials to an applied strain can be continuous, or instead display a macroscopic stress drop when a shear band nucleates. Such discontinuous response can be observed if the initial configuration is very stable.…
Soft adhesive pads are needed for many robotics applications, and one approach is based on electroadhesion. Here we present a general analytic model and numerical results for electroadhesion for soft solids with arbitrary time-dependent…
A highly deformable rod, modelled as the extensible elastica, is connected to a movable clamp at one end and to a pin sliding along a frictionless curved profile at the other. Bifurcation analysis shows that axial compliance provides a…
When quickly detaching an elastomer from a counterface, viscoelasticity dramatically increases the perceived adhesion relative to its adiabatic or equilibrium value. Here, we report simulations on the sticking contact between a rigid…
Although it is often asserted that, in view of their reduced length, axially compressible beams have a higher buckling load than their inextensible counterpart, a detailed analysis demnstrates that this is not necessarily the case. The…
The inclusion of rigid elements into elastic composites may lead to superior mechanical properties for the equivalent elastic continuum, such as, for instance, extreme auxeticity. To allow full exploitation of these properties, a tool for…
Compressive mechanical stress exceeding a critical value leads to the formation of periodic surface buckling patterns in film-substrate systems. A comprehensive understanding of this buckling phenomenon is desired in applications where the…
Biological cells in soft materials can be modeled as anisotropic force contraction dipoles. The corresponding elastic interaction potentials are long-ranged ($\sim 1/r^3$ with distance $r$) and depend sensitively on elastic constants,…
The Plateau-Rayleigh instability shows that a cylindrical fluid flow can be destabilized by surface tension. Similarly, capillary forces can make an elastic cylinder unstable when the elastocapillary length is comparable to the cylinder's…
A 3D unit cell model containing eight different spherical particles embedded in a homogeneous strain gradient plasticity (SGP) matrix material is presented. The interaction between particles and matrix is controlled by an interface model…
A law previously found for shear moduli of crystalline materials is developed and extended to all elastic moduli in solids and structures. Shear moduli were previously shown to depend only on specific volume. The bulk moduli of many…
When deformed, liquid foams tend to raise their liquid contents like immersed granular materials, a phenomenon called dilatancy. We have aready described a geometrical interpretation of elastic dilatancy in 3D foams and in very dry foams…
The classical flexure problem of non-linear incompressible elasticity is revisited for elastic materials whose mechanical response is different in tension and compression---the so-called bimodular materials. The flexure problem is chosen to…
We show how bilateral, linear, elastic foundations (i.e. Winkler foundations) often regarded as heuristic, phenomenological models, emerge asymptotically from standard, linear, three-dimensional elasticity. We study the parametric…
The elastocapillary instability of a flexible plate plunged in a liquid bath is analysed theoretically. We show that the plate can bend due to two separate destabilizing mechanisms, when the liquid is partially wetting the solid. For…