Related papers: Critical processing temperature for high performan…
We perform in-situ two-cycle thermal cycling and annealing studies for a transferred CVD-grown monolayer MoS2 on a SiO2/Si substrate, using spatially resolved micro-Raman and PL spectroscopy. After the thermal cycling and being annealed at…
A key challenge for quantum photonic technologies based on spin qubits is the creation of optically active defects in photonic resonators. Several of the most promising defects for quantum applications are hosted in diamond, and are…
The "metallic" temperature variation of the electrical resistivity of chemical nano gold-silver coatings with a silver content of 6.6 % at. up to 13.1 % at. determined in the temperature range 4.2-300 K. Features of low-temperature…
A complete experimental study of temperature dependence of the total spectral emissivity has been performed, for the first time, for absorber reflector selective coatings used in concentrated solar power (CSP) systems for energy harvesting.…
To study the size and strain rate dependency of copper polycrystalline microstructures, a multi-layered copper/Al$_2$O$_3$ thin film was deposited on a Si substrate using a hybrid deposition system (combining physical vapour and atomic…
Copper ferrite thin films were deposited on amorphous quartz substrates. The as deposited films were annealed in air and either quenched or slow cooled. Magnetization studies were carried out on the as deposited as well as annealed films…
Monophasic and homogeneous Ni10Zr7 nanocrystalline alloy films were successfully grown at room temperature by co-sputtering in an indigenously developed three-gun DC/RF magnetron sputtering unit. The films could be produced with long-range…
Pulsed laser deposition from a Nd:YAG laser was employed in production of hundreds of nanometer thick quasicrystalline Ti-Zr-Ni films on glass substrate. The influence of deposition temperature Ts on the structure, morphology and…
Single-sided aluminized polyimide films (SAPF) are widely used in thermal management of aerospace systems. Although the reliability of SAPF in space environments has been thoroughly studied, its reliability in ground environments during…
Context. Evaporative (sublimation) cooling of icy interstellar grains occurs when the grains have been suddenly heated by a cosmic-ray (CR) particle or other process. It results in thermal desorption of icy species, affecting the chemical…
Superconducting thin films have been prepared in a two-step in-situ process, using the Mg-B plasma generated by pulsed laser ablation. The target was composed of a mixture of Mg and MgB2 powders to compensate for the volatility of Mg and…
Ga-rich GaAs (001) surfaces are successfully observed during high-temperature annealing by scanning tunneling microscopy (STM). With a substrate temperature of 550 C, reflection high-energy diffraction patterns and reflectance anisotropy…
In this work, a metamaterial selective solar absorber made of nanostructured titanium gratings deposited on an ultrathin MgF2 spacer and a tungsten ground film is proposed and experimentally demonstrated. Normal absorptance of the…
Copper oxide thin films are deposited on quartz substrates by DC magnetron sputtering and the effect of deposition temperature on their optoelectronic properties is examined in detail. Scanning Electron Microscopy (SEM), X-ray diffraction…
The problem of detecting the ability of some metal oxides as photocatalysts is receiving considerable attention in the world. The studied zinc oxide is considered as one of the most utilized semiconductors, due to its direct band gap of…
The effect of damage induced by 2-MeV alpha particles, followed by annealing, on the critical temperature (Tc), resistivity, and upper critical field (Hc2), of three MgB2 films made by different deposition processes has been studied. Damage…
We fabricated superconducting MgB2 thin films on (001) MgO substrates. The samples were prepared by magnetron rf and dc co-sputtering on heated substrates. They were annealed ex-situ for one hour at temperatures between 450{\deg}C and…
Micron-thick boron films have been deposited by Pulsed Laser Deposition in vacuum on several substrates at room temperature. The use of high energy pulses (>700 mJ) results in the deposition of smooth coatings with low oxygen uptake even at…
We developed a broadband two-layer anti-reflection (AR) coating for use on a sapphire half-wave plate (HWP) and an alumina infrared (IR) filter for the cosmic microwave background (CMB) polarimetry. Measuring the faint CMB B-mode signals…
Nb3Sn and V3Si thin films are promising candidates as thin films for the next generation of superconducting radio-frequency (SRF) cavities. However, sputtered films often suffer from stoichiometry and strain issues during deposition and…