Related papers: Buckling and post-buckling of a compressed elastic…
Gels are used to design bilayered structures with high residual stresses. The swelling of a thin layer on a compliant substrate leads to compressive stresses. The post-buckling of this layer is investigated experimentally; the wavelengths…
A thin flat rectangular plate supported on its edges and subjected to in-plane loading exhibits stable post-buckling behaviour. However, the introduction of a nonlinear (softening) elastic foundation may cause the response to become…
Fiber-reinforcement is a universal feature of many biological tissues. It involves the interplay between fiber stiffness, fiber orientation, and the elastic properties of the matrix, influencing pattern formation and evolution in layered…
A block of rubber eventually buckles under severe flexure, and several axial wrinkles appear on the inner curved face of the bent block. Experimental measurements reveal that the buckling occurs earlier ---at lower compressive strains---…
If carbon fibre layers are prevented from slipping over one another as they consolidate onto a non-trivial geometry, they can be particularly susceptible to wrinkling/buckling instabilities. A one dimensional model for wrinkling during…
We consider mechanically-induced pattern formation within the framework of a growing, planar, elastic rod attached to an elastic foundation. Through a combination of weakly nonlinear analysis and numerical methods, we identify how the shape…
The buckling of a soft elastic sample under growth or swelling has highlighted a new interest in materials science, morphogenesis, and biology or physiology. Indeed, the change of mass or volume is a common fact of any living species, and…
Euler buckling epitomises mechanical instabilities: An inextensible straight elastic line buckles under compression when the compressive force reaches a critical value $F_\ast>0$. Here, we extend this classical, planar instability to the…
Wrinkles are often observed on the surfaces of compressed soft materials in nature. In the past few decades, the fascinating surface patterns have been studied extensively by using the linear bifurcation analysis under plane strain. The…
We investigate wrinkling of two-dimensional random and triangular semiflexible polymer networks under shear. Both types of semiflexible networks exhibit wrinkling above a small critical shear angle, which scales with an exponent of the…
A famous and thoroughly investigated instability set-up, susceptible to wrinkling and creasing, consists of an elastic half-space being prestressed under a dead load, applied at infinity and, possibly, on its surface. We consider the case…
Instability patterns of rolling up a sleeve appear more intricate than the ones of walking over a rug on floor, both characterized as uniaxially compressed soft-film/stiff-substrate systems. This can be explained by curvature effects. To…
For curves of prescribed length embedded into the unit disc in two dimensions, we obtain scaling results for the minimal elastic energy as the length just exceeds $2\pi$ and in the large length limit. In the small excess length case, we…
In layered materials, a common mode of deformation involves buckling of the layers under tensile deformation in the direction perpendicular to the layers. The instability mechanism, which operates in elastic materials from geological to…
Active control of wrinkling in soft film-substrate composites using electric fields is a critical challenge in tunable material systems. Here, we investigate the electro-mechanical instability of a soft dielectric film bonded to a…
We study the buckling of a one fiber composite whose matrix stiffness is slightly dependent on the compressive force. We show that the equilibrium curves of the system exhibit a limit load when the induced stiffness parameter gets bigger…
Bifurcation of an elastic structure crucially depends on the curvature of the constraints against which the ends of the structure are prescribed to move, an effect which deserves more attention than it has received so far. In fact, we show…
We study the nucleation and development of crack patterns in thin composite fibers under tension in this work. A fiber comprises an elastic core and an outer layer of a weaker brittle material. In recent tensile experiments on such…
The properties of a hinged floating elastic sheet of finite length under compression are considered. Numerical continuation is used to compute spatially localized buckled states with many spatially localized folds. Both symmetric and…
Molecular dynamics simulations are performed to investigate the buckling of single-layer MoS2 under uniaxial compression. The strain rate is found to play an important role on the critical buckling strain, where higher strain rate leads to…