Related papers: Simulation of wake bimodality behind squareback bl…
This work focuses on the validation of the dynamic wake meandering (DWM) model against large eddy simulation (LES). The wake deficit, mean deflection, and meandering under different wind turbine misalignment angles in yaw and tilt, for the…
This study utilizes Large Eddy Simulation (LES) to investigate the impact of longitudinal triangular riblets on the laminar-to-turbulent transition in boundary layer flow. Five cases are examined: one involving a flat plate and four with…
Natural ventilation is gaining popularity in response to an increasing demand for a sustainable and healthy built environment, but the design of a naturally ventilated building can be challenging due to the inherent variability in the…
A large eddy simulation (LES) with an extended Smagorinsky model has been carried to investigate numerically the fully developed turbulent flow of a shear thinning fluid (n=0.75) in a stationary pipe at a simulation's Reynolds number equals…
Flexible structures in an incoming perpendicular flow typically undergo elastic reconfiguration that reduces drag; however, at higher velocities, they are prone to dynamical instabilities that entail complex wake dynamics and fluctuating…
This article proposes a Reynolds number scaling of the required grid points to perform wall-modeled LES of turbulent flows encountering separation off a solid surface. Based on comparisons between the various time scales in a…
Flows in square channels are common in applications, such as automotive after-treatment systems and heat exchangers. Flows with axial flow entry are well understood, but for oblique flow entry, there is no clarity on the additional pressure…
In the last decade, progresses in additive manufacturing (AM) have paved the way for optimized heat exchangers, whose disruptive design will depend on predictive numerical simulations. Typical AM rough surfaces show limited resemblance to…
We consider the wake flow past a thin two-dimensional flat plate normal to the uniform stream and demonstrate that this flow is turbulent already at a relatively low Reynolds number of $Re = 400$. This is achieved by performing a careful…
Microscale turbulence in porous media is a new physical phenomenon that exhibits unique properties unlike those in classical turbulence flows. At low values of porosity, the surface forces on the solid obstacles compete with the inertial…
A turbulent side-wall quenching (SWQ) flame in a fully developed channel flow is studied using Large-Eddy Simulation (LES) with a tabulated chemistry approach. Three different flamelet manifolds with increasing levels of complexity are…
A new wall-wake law is proposed for the streamwise turbulence in the outer region of a turbulent boundary layer. The formulation pairs the logarithmic part of the profile (with a slope A_1 and additive constant B_1) to an outer linear part,…
The dynamics of a three-dimensional axisymmetric bluff-body wake are examined at low Reynolds regimes where transitions take place through spatio-temporal symmetry breaking. A linear stability analysis is employed to identify the critical…
We study numerically the two-dimensional flow past a circular cylinder as a prototypical transitional flow, and investigate the influence of a generic slip boundary condition on the wake dynamics. We show that slip significantly delays the…
The wake of wavy cylinder has been shown to exhibit bistability. Depending on the initial condition, the final state of the wake can either develop into a steady flow (state I), or periodic shedding (state II). In this paper, we perform…
We investigate the global frequency selection of two-dimensional vortex shedding in the flat plate wake. The analysis is based on the mean flow velocity profiles obtained from experimental measurements carried out for two values of Reynolds…
Direct numerical simulations (DNS) are one of the main ab initio tools to study turbulent flows. However, due to their considerable computational cost, DNS are primarily restricted to canonical flows at moderate Reynolds numbers, in which…
This paper investigates the linear destabilization of three-dimensional steady wakes developing behind flate plates placed normal to the incoming flow. Plates characterized by low length-to-width ratio $L$ are considered here. By varying…
This study presents a systematic validation and comparative assessment of computational fluid dynamics (CFD) strategies for centrifugal blood pump simulations using the U.S. Food and Drug Administration benchmark model. A scale-resolving…
Large-eddy simulation (LES) is able to capture key boundary-layer (BL) turbulence and cloud processes. Yet, large-scale forcing and surface turbulent fluxes of sensible and latent heat are often poorly prescribed for LES simulations. We…