Related papers: An Efficient Interference-Aware Constrained Massiv…
Multi-Input Multi-Output (MIMO) techniques have been incorporated with Orthogonal Frequency Division Multiplexing (OFDM) for broadband wireless communication systems. Bit-Interleaved Coded Multiple Beamforming (BICMB) can achieve both…
Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
Microwave linear analog computing (MiLAC) has recently emerged as a promising architecture for analog-domain beamforming. In particular, a hybrid digital-MiLAC architecture was proposed and was shown to achieve fully-digital beamforming…
This paper investigates the joint design of the beamforming scheme in intelligent reflecting surface (IRS) assisted multiuser (MU) multiple-input multiple-output (MIMO) downlink transmissions. Channel estimation errors associated with the…
Continuous efforts have been devoted to integrate millimeter wave (mmWave) and terahertz (THz) bands into future communication standards in order to overcome the bandwidth shortage problem and achieve high data rates, primarily through…
This paper studies optimal joint beamforming (BF) for joint sensing and communication (JSAC) in small-scale cell-free MIMO (CF-MIMO) systems. While prior works have explored JSAC optimization using methods such as successive convex…
Millimeter wave (mmWave) communications have been considered as a key technology for future 5G wireless networks. In order to overcome the severe propagation loss of mmWave channel, mmWave multiple-input multiple-output (MIMO) systems with…
The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…
For massive MIMO public channel with any sector size in either microwave or millimeter wave (mmwave) band, this paper studies the beamforming design to minimize the transmit power while guaranteeing the quality of service (QoS) for randomly…
Federated learning (FL) with over-the-air computation can efficiently utilize the communication bandwidth but is susceptible to analog aggregation error. Excluding those devices with weak channel conditions can reduce the aggregation error,…
We consider the interference management problem in a multicell MIMO heterogenous network. Within each cell there are a large number of distributed micro/pico base stations (BSs) that can be potentially coordinated for joint transmission. To…
We consider minimum mean square error (MMSE) joint precoder and combiner design for single and multi carrier distributed beamforming systems with nonuniform per-antenna transmit power constraints. We show that, similar to the maximum-gain…
Leveraging the available millimeter wave spectrum will be important for 5G. In this work, we investigate the performance of digital beamforming with low resolution ADCs based on link level simulations including channel estimation, MIMO…
Hybrid precoding design can be challenging for broadband millimeter-wave (mmWave) massive MIMO due to the frequency-flat analog precoder in radio frequency (RF). Prior broadband hybrid precoding work usually focuses on fully-connected array…
Multicast beamforming is known to improve spectral efficiency. However, its benefits and challenges for hybrid precoders design in millimeter-wave (mmWave) systems remain understudied. To this end, this paper investigates the first joint…
In this paper, we consider the problem of joint antenna selection and analog beamformer design in downlink single-group multicast networks. Our objective is to reduce the hardware costs by minimizing the number of required phase shifters at…
Large antenna arrays will be needed in future millimeter wave (mmWave) cellular networks, enabling a large number of different possible antenna architectures and multiple-input multiple-output (MIMO) techniques. It is still unclear which…
This paper studies the joint multicast beamforming and user scheduling problem, with the objective of minimizing total transmitting power across multiple channels by jointly assigning each user to appropriate channel and designing multicast…
Both dual-functional radar-communication (DFRC) and massive multiple-input multiple-output (MIMO) have been recognized as enabling technologies for 6G wireless networks. This paper considers the advanced waveform design for…