Related papers: Comparing Two- and Three-Dimensional Models of Scr…
Isothermal fluid turbulence simulations have been performed in the edge and scrape-off-layer (SOL) of an analytic stellarator configuration with an island divertor, thereby providing numerical insight into edge turbulence in regions around…
Two dimensional stochastic time model of scrape-off layer (SOL) turbulent transport is studied. Instability arisen in the system with respect to the stochastic perturbations of both either density or vorticity reveals itself in the strong…
Typically, fluid simulations are used for tokamak divertor design. However, fluid models are only valid if the SOL is highly collisional, an assumption that is valid in many present day experiments but is questionable in the high-power…
We consider the two-dimensional (2D) flow in a flat free-slip surface that bounds a three-dimensional (3D) volume in which the flow is turbulent. The equations of motion for the two-dimensional flow in the surface are neither compressible…
We examine the effect of different radiative transfer schemes on the properties of 3D simulations of near-surface stellar convection in the superadiabatic layer, where energy transport transitions from fully convective to fully radiative.…
The power load to the divertor surfaces is a key concern for future devices such as ITER, due to the thermal limits on the material surface. One factor that characterizes the heat flux to the divertor is the fall off length in the…
Numerical 3D radiative (M)HD simulations of solar convection are used to understand the physical properties of the solar photosphere. To validate this approach, it is important to check that no excessive thermodynamic fluctuations arise as…
Optimizing the performance of magnetic confinement fusion devices is critical to achieving an attractive fusion reactor design. Negative triangularity (NT) scenarios have been shown to achieve excellent levels of energy confinement, while…
Numerical modeling of the edge and scrape-off layer (SOL) must account for atomic processes such as hydrogenic ionization and recombination, charge-exchange, and line radiation. Their reaction rates depend non-linearly on density and…
A multidiagnostic approach, utilizing Langmuir probes in the midplane, X-point and divertor walls, along with Lithium beam and infrared measurements is employed to evaluate the evolution of the Scrape-off Layer (SOL) of ASDEX Upgrade across…
Two-dimensional fluid simulations of interchange turbulence for geometry and parameters relevant for the scrape-off layer of confined plasmas are presented. We observe bursty ejection of particles and heat from the bulk plasma in the form…
The ${\bm E}\times{\bm B}$ drift motion of charged test particle dynamics in the Scrape Off Layer (SOL)is analyzed to investigate a transport control strategy based on Hamiltonian dynamics. We model SOL turbulence using a 2D non-linear…
Simulations of turbulent flows in 3D are one of the most expensive simulations in computational fluid dynamics (CFD). Many works have been written on surrogate models to replace numerical solvers for fluid flows with faster, learned,…
Direct numerical simulations were performed to characterize fully developed supersonic turbulent channel flows over isothermal rough walls. The effect of roughness was incorporated using a level-set/volume-of-fluid immersed boundary method.…
Turbulence modeling has the potential to revolutionize high-speed vehicle design by serving as a co-equal partner to costly and challenging ground and flight testing. However, the fundamental assumptions that make turbulence modeling such…
This paper describes a series of 3D simulations of shallow inefficient convection in the outer layers of the Sun. The computational domain is a closed box containing the convection-radiation transition layer, located at the top of the solar…
Large-eddy simulations are conducted to contrast momentum and passive scalar transport over large, three-dimensional roughness elements in a turbulent channel flow. Special attention is given to the dispersive fluxes, which are shown to be…
Turbulent dynamics in the scrape-off layer (SOL) of magnetic fusion devices is intermittent with large fluctuations in density and pressure. Therefore, a model is required that allows perturbations of similar or even larger magnitude to the…
The SOL width is a parameter of paramount importance in modern tokamaks as it controls the power density deposited at the divertor plates, critical for plasma-facing material survivability. An understanding of the parameters controlling it…
The present work compares results for different numerical methods in search of alternatives to improve the quality of large-eddy simulations for the problem of supersonic turbulent jet flows. Previous work has analyzed supersonic jet flows…