Related papers: Tomlinson-Harashima Precoding with Stream Combiner…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
In millimeter-wave (mmWave) MIMO systems, while a hybrid digital/analog precoding structure offers the potential to increase the achievable rate, it also faces the challenge of the need of a low-complexity design. In specific, the hybrid…
Reconfigurable intelligent surfaces (RISs) have huge potential to improve spectral and energy efficiency in future wireless systems at a minimal cost. However, early prototype results indicate that deploying hundreds or thousands of…
This paper considers a multi-user multiple-input multiple-output (MU-MIMO) system where the precoding matrix is selected in a baseband unit (BBU) and then sent over a digital fronthaul to the transmitting antenna array. The fronthaul has a…
Rate-splitting multiple access (RSMA), relying on linearly precoded rate-splitting (RS) at the transmitter and successive interference cancellation (SIC) at the receivers has emerged as a powerful and flexible multiple access strategy for…
Rate-Splitting Multiple Access (RSMA) has emerged as a potent and reliable multiple access and interference management technique in wireless communications. While downlink Multiple-Input Multiple-Ouput (MIMO) RSMA has been widely…
Multiuser multiple-input multiple-output wireless communications systems have the potential to satisfy the performance requirements of fifth-generation and future wireless networks. In this context, cell-free (CF) systems, where the…
MIMO systems are considered as most promising for wireless communications. However, with an increasing number of radio front ends the corresponding energy consumption and costs become an issue, which can be relieved by the utilization of…
This paper studies the performance of single-input multiple-output (SIMO) systems under receive antenna selection (RAS) and BPSK/QPSK modulations. At the receiver, a subset of branches are selected and combined using maximal-ratio combining…
This work deals with turbo coded single user massive multiple input multiple output (SU-MMIMO) systems, with and without precoding. SU-MMIMO has a much higher spectral efficiency compared to multi-user massive MIMO (MU-MMIMO) since…
Hybrid precoding, which consists of an RF precoder and a baseband precoder, is a popular precoding architecture for massive MIMO due to its low hardware cost and power consumption. In conventional hybrid precoding, both RF and baseband…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
The performance of modern wireless communication systems is typically limited by interference. The impact of interference can be even more severe in ultra-reliable and low-latency communication (URLLC) use cases. A powerful tool for…
The focus of this paper is on multi-user MIMO transmissions for millimeter wave systems with a hybrid precoding architecture at the base-station. To enable multi-user transmissions, the base-station uses a cell-specific codebook of…
Terahertz (THz) cell-free massive multiple-input-multiple-output (mMIMO) networks have been envisioned as a prospective technology for achieving higher system capacity, improved performance, and ultra-high reliability in 6G networks.…
Large antenna arrays will be needed in future millimeter wave (mmWave) cellular networks, enabling a large number of different possible antenna architectures and multiple-input multiple-output (MIMO) techniques. It is still unclear which…
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
We propose a subspace constrained precoding scheme that exploits the spatial channel correlation structure in massive MIMO cellular systems to fully unleash the tremendous gain provided by massive antenna array with reduced channel state…
We investigate quantization and feedback of channel state information in a multiuser (MU) multiple input multiple output (MIMO) system. Each user may receive multiple data streams. Our design minimizes the sum mean squared error (SMSE)…
In this work, we propose a low-cost rate splitting (RS) technique for a multi-user multiple-input single-output (MISO) system operating in frequency division duplex (FDD) mode. The proposed iterative optimisation algorithm only depends on…