Related papers: Thermoelectric Sensors as Microcalorimeter Load
A silicon-based fine granularity calorimeter is a potential technology for the future International Linear Collider ILC, the future circular collider CEPC, and is also the chosen technology for the upgraded CMS experiment of the Large…
Multi Layer Capacitors MLCs are considered as the most promising refrigerant elements to design and develop electrocaloric cooling devices. Recently, the heat transfer of these MLCs has been considered. However, the heat exchange with the…
At National Institute of Metrological Research (INRIM), a selectable-value Transportable High dcVoltage Standard (THVS) operating in the range from 10 V to 100 V in steps of 10 V, was developed. This Standard was built to cover the lack of…
We calculate the operating parameters of a transition edge sensor that is mounted on a thin dielectric membrane with the assumption that the phononic heat transport in the membrane is ballistic. Our treatment uses the correct phonon modes…
The determination of the neutrino mass is an open issue in modern particle physics and astrophysics. The direct mass measurement is the only theory-unrelated experimental tool capable to probe such quantity. The HOLMES experiment aims to…
Common thermal anemometers (hot-wire, hot-film, or similar) are based on the thermal equilibrium between the electrical power heating the sensor and the convection of the ambient medium cooling the sensor. The response times of such…
Raman thermometry is advantageous for measuring the thermal transport of low-dimensional materials due to its non-contact nature. Transient Raman methods have improved the accuracy of steady-state Raman thermometry by removing the need for…
Infrared (IR) radiation detectors are used in numerous applications from thermal imaging to spectroscopic gas sensing. Obtaining high speed and sensitivity, low-power operation and cost-effectiveness with a single technology remains to be a…
Quantum metrology is being gradually studied for weak measurement systems. For weak measurement systems with thermal state pointer, we find that in the displacement space corresponding to imaginary weak values, the maximal QFI after…
We report on an optimized micro-machined thermal flow-rate sensor as part of an autonomous multi-parameter sensing device for water network monitoring. The sensor has been optimized under the following constraints: low power consumption and…
When a quantum dot is subjected to a thermal gradient, the temperature of electrons entering the dot can be determined from the dot's thermocurrent if the conductance spectrum and background temperature are known. We demonstrate this…
Resistance thermometry provides a time-tested method for taking temperature measurements that has been painstakingly developed over the last century. However, fundamental limits to resistance-based approaches along with a desire to reduce…
We describe the design and performance of a series of fast, precise current sensing noise thermometers. The thermometers have been fabricated with a range of resistances from 1.290 $\Omega$ down to 0.2 m$\mathrm{\Omega}$. This results in…
We describe a compact calorimeter that opens ultra-low temperature heat capacity studies of small metal crystals in moderate magnetic fields. The performance is demonstrated on the canonical heavy Fermion metal YbRh2Si2. Thermometry is…
A temperature controlled 1 {\Omega}-10 k{\Omega} standard Resistors transportable setup was developed at National Institute of Metrological Research, (INRIM) for the calibration and adjustment of multifunction electrical instruments. The…
We present radio-frequency thermometry based on a tunnel junction between a superconductor and proximitized normal metal. It allows operation in a wide range of biasing conditions. We demonstrate that the standard finite-bias quasiparticle…
A proximity-effect thermometer measures the temperature dependent critical supercurrent in a long superconductor - normal metal - superconductor (SNS) Josephson junction. Typically, the transition from the superconducting to the normal…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
It was recently suggested that molecular junctions would be excellent elements for efficient and high-power thermoelectric energy conversion devices. However, experimental measurements of thermoelectric conversion in molecular junctions…
Wireless monitoring sensor gradually replaces wired equipment for data support in petrochemical industry production. And wireless monitoring sensor with continuous energy supply is necessary and still faces great challenges. Thermoelectric…