Related papers: Constant TMR magnetic field sensor detectivity wit…
A custom-developed magneto-mechanical resonator (MMR) for wireless pressure measurement is investigated for potential applications in process engineering. The MMR sensor utilises changes in the resonance frequency caused by pressure on a…
We demonstrate the sensitivity of a sensor based on an optically-pumped radio-frequency (RF) atomic magnetometer to the polarization state of the detected RF magnetic field, and measure $>$36 dB difference in amplitude sensitivity for…
Randomization of the trap state of defects present at the gate Si-SiO$_2$ interface of MOSFET is responsible for the low-frequency noise phenomena such as Random Telegraph Signal (RTS), burst, and 1/\textit{f} noise. In a previous work,…
For the generation of static magnetic fields solenoids are frequently used for the purpose of research and development of magnetic field sensors. When such a sensor is to be analyzed with regard to its inherent noise the influence of other…
Precision sensing, and in particular high precision magnetometry, is a central goal of research into quantum technologies. For magnetometers, often trade-offs exist between sensitivity, spatial resolution, and frequency range. The…
Magnetoelectric (ME) magnetic field sensors commonly rely on one of the two modulation principles: the nonlinear dependence of magnetostrictive strain on the applied field or the stress-induced change in magnetization susceptibility. While…
Low frequency noise close to the carrier remains little explored in spin torque nano oscillators. However, it is crucial to investigate as it limits the oscillator's frequency stability. This work addresses the low offset frequency flicker…
We present a comparative study of high frequency dynamics and low frequency noise in elliptical magnetic tunnel junctions with lateral dimensions under 100 nm presenting current-switching phenomena. The analysis of the high frequency…
We report the bias voltage controlled inversions of tunneling magnetoresistance (TMR) in magnetic tunnel junctions composed of Fe3GaTe2 electrodes and hBN tunneling barrier, observed at room temperature. The polarity reversal of TMR occurs…
Sensing static or slowly varying magnetic fields with high sensitivity and spatial resolution is critical to many applications in fundamental physics, bioimaging and materials science. Several versatile magnetometry platforms have emerged…
Here we report a custom design setup for the simultaneous measurement of magneto-resistance and MOKE imaging in longitudinal configuration for characterization of magnetic thin-films and sensors. The setup is designed so as to cope with a…
We report that low frequency (up to 200 kHz) noise spectra of magnetic tunnel junctions with areas ~10^{-10}cm^2$ at 10 Kelvin deviate significantly from the typical 1/f behavior found in large area junctions at room temperature. In most…
Solid state defects such as nitrogen vacancy (NV) centers in diamond have been utilized for NMR sensing at ambient temperatures for samples at the nano-scale and up to the micro-scale. Similar to standard NMR, NV-sensitivities can be…
Thermal-magnetic noise at ferromagnetic resonance (T-FMR) can be used to measure magnetic perpendicular anisotropy of nanoscale magnetic tunnel junctions (MTJs). For this purpose, T-FMR measurements were conducted with an external magnetic…
Low temperature (10K) high voltage bias dynamic conductivity (up to 2.7V) and shot noise (up to 1V) were studied in epitaxial Fe(100)/Fe-C/MgO(100)/Fe(100) magnetic tunnel junctions, as a function of the magnetic state. The junctions show…
In gate-defined quantum dot systems, the conductance change of electrostatically coupled sensor dots allows the observation of the quantum dots' charge and spin states. Therefore, the sensor dot must be optimally sensitive to changes in its…
Bounds on the amplitude of a scale-invariant stochastic primordial magnetic field (PMF) can be significantly improved by measurements of the Faraday Rotation (FR) of CMB polarization. The mode-coupling correlations induced by FR make it…
Purpose: Low-field MRI systems operate at single MHz-range frequencies, where signal losses are primarily dominated by thermal noise from the radio-frequency (RF) receive coils. Achieving operation close to this limit is essential for…
We report transport measurements as a function of bias in open semiconductor quantum dots. These measurements are well described by an effective electron temperature derived from Joule heating at the point contacts and cooling by…
We reported a systematic study of spin-orbit torque biased magnetic sensors based on NiFe/Pt bilayers through both macro-spin modeling and experiments. The simulation results show that it is possible to achieve a linear sensor with a…