Related papers: Cognitive-Driven Optimization of Sparse Array Tran…
Intelligent metasurfaces may be harnessed for realizing efficient holographic multiple-input and multiple-output (MIMO) systems, at a low hardware-cost and high energy-efficiency. As part of this family, we propose a hybrid beamforming…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) wireless multi-relay network, in which a source-destination pair both equipped with multiple antennas communicates through multiple half-duplex amplify-and-forward…
Milimeter wave (mmWave) band mobile communications can be a solution to the continuously increasing traffic demand in modern wireless systems. Even though mmWave bands are scarcely occupied, the design of a prospect transceiver should…
This paper presents a physics-consistent framework for bistatic sensing incorporating a 2-Dimensional (2D) waveguide-fed metasurface antenna array capable of realizing eXtremely-Large Multiple-Input Multiple-Output (XL MIMO) apertures. A…
Partial feedback in multiple-input multiple-output (MIMO) communication systems provides tremendous capacity gain and enables the transmitter to exploit channel condition and to eliminate channel interference. In the case of severely…
In this paper, we study optimal waveform design to maximize mutual information (MI) for a joint communication and (radio) sensing (JCAS, a.k.a., radar-communication) multi-input multi-output (MIMO) downlink system. We consider a typical…
In mmWave massive multiple-input multiple-output (mMIMO) systems, hybrid digital/analog beamforming has been recognized as an economic means to overcome the severe mmWave propagation loss. To facilitate beamforming for mmWace mMIMO, there…
This paper investigates the two-timescale transmission design for reconfigurable intelligent surface (RIS)-aided massive multiple-input multiple-output (MIMO) systems, where the beamforming at the base station (BS) is adapted to the…
This letter exploits moving arrays to enable nearfield multiple-input multiple-output (MIMO) sensing via a limited number of antenna elements. We consider a scenario where a base station (BS) is equipped with a uniform linear array (ULA) on…
Reconfigurable intelligent surface (RIS) refers to a signal reflection surface containing a large number of low-cost passive reflecting elements. RIS can improve the performance of radar and communication systems by dynamically modulating…
Reconfigurable distributed antenna and reflecting surface (RDARS) is a promising architecture for future sixth-generation (6G) wireless networks. In particular, the dynamic working mode configuration for the RDARS-aided system brings an…
A MIMO dual-function radar communication (DFRC) system transmitting orthogonal time frequency space (OTFS) waveforms is considered. A key advantage of MIMO radar is its ability to create a virtual array, achieving higher sensing resolution…
This paper proposes an adaptive multi-mode transmission strategy to improve the spectral efficiency achieved in the multiple-input multiple-output (MIMO) broadcast channel with delayed and quantized channel state information. The adaptive…
This paper proposes a reinforcement learning (RL)-aided cognitive framework for massive MIMO-based integrated sensing and communication (ISAC) systems employing a uniform planar array (UPA). The focus is on enhancing radar sensing…
A key component of cognitive radar is the ability to generalize, or achieve consistent performance across a range of sensing environments, since aspects of the physical scene may vary over time. This presents a challenge for learning-based…
Geometric environment information aids future distributed radio infrastructures in providing services, such as ultra-reliable communication, positioning, and wireless power transfer (WPT). An a priori known environment model cannot always…
High-mobility adaption and massive Multiple-input Multiple-output (MIMO) application are two primary evolving objectives for the next generation high speed train communication system. In this paper, we consider how to design a…
In diffusion-based communication, as for molecular systems, the achievable data rate is very low due to the slow nature of diffusion and the existence of severe inter-symbol interference (ISI). Multiple-input multiple-output (MIMO)…
Flexible intelligent metasurfaces (FIMs) show great potential for improving the wireless network capacity in an energy-efficient manner. An FIM is a soft array consisting of several low-cost radiating elements. Each element can…
In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…