Related papers: On Single-User Interactive Beam Alignment in Milli…
In millimeter wave communications, beam training is an effective way to achieve beam alignment. Traditional beam training method allocates training resources equally to each beam in the pre-designed beam training codebook. The performance…
Millimeter wave (mmWave) communication with large antenna arrays is a promising technique to enable extremely high data rates due to the large available bandwidth in mmWave frequency bands. In addition, given the knowledge of an optimal…
Huge overhead of beam training imposes a significant challenge in millimeter-wave (mmWave) wireless communications. To address this issue, in this paper, we propose a wide beam based training approach to calibrate the narrow beam direction…
Mobility scenarios involving short contact times pose a challenge for high bandwidth data transfer between autonomous vehicles and roadside base stations (BS). Millimeter wave bands are a viable solution as they offer enormous bandwidth in…
Ultra-reliable and low-latency connectivity is required for real-time and latency-sensitive applications, like wireless augmented and virtual reality streaming. Millimeter-wave (mmW) networks have enabled extremely high data rates through…
In this paper, we studied the problem of beam alignment for millimeter wave (mmWave) communications, in which we assume a hybrid analog and digital beamforming structure is employed at the transmitter (i.e. base station), and an…
Millimeter-wave (mmWave) and terahertz (THz) communication systems adopt large antenna arrays to ensure adequate receive signal power. However, adjusting the narrow beams of these antenna arrays typically incurs high beam training overhead…
Emerging wireless communication systems will be characterized by a tight coupling between communication and positioning. This is particularly apparent in millimeter-wave (mm-wave) communications, where devices use a large number of antennas…
Accurate channel parameter estimation is challenging for wideband millimeter-wave (mmWave) large-scale hybrid arrays, due to beam squint and much fewer radio frequency (RF) chains than antennas. This paper presents a novel joint delay and…
The focus of this work is on the analysis of transmit beamforming schemes with a low-rate feedback link in wireless sensor/relay networks, where nodes in the network need to implement beamforming in a distributed manner. Specifically, the…
While initial beam alignment (BA) in millimeter-wave networks has been thoroughly investigated, most research assumes a simplified terminal model based on uniform linear/planar arrays with isotropic antennas. Devices with non-isotropic…
Analog beamforming with phased arrays is a promising technique for 5G wireless communication in millimeter wave bands. A beam focuses on a small range of angles of arrival or departure and corresponds to a set of fixed phase shifts across…
Millimeter-wave is one of the technologies powering the new generation of wireless communication systems. To compensate the high path-loss, millimeter-wave devices need to use highly directional antennas. Consequently, beam misalignment…
Mobile users are prone to experience beam failure due to beam drifting in millimeter wave (mmWave) communications. Sensing can help alleviate beam drifting with timely beam changes and low overhead since it does not need user feedback. This…
In a typical communication system, in order to maintain a desired SNR level, initial beam alignment (BA) must be established prior to data transmission. In a setup where a Base Station (BS) Tx sends data via a digitally modulated waveform,…
In millimeter wave cellular communication, fast and reliable beam alignment via beam training is crucial to harvest sufficient beamforming gain for the subsequent data transmission. In this paper, we establish fundamental limits in…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…
Millimeter wave (mmWave) communication is expected to play an important role in next generation cellular networks, aiming to cope with the bandwidth shortage affecting conventional wireless carriers. Using side-information has been proposed…
A local Bundle Adjustment (BA) on a sliding window of keyframes has been widely used in visual SLAM and proved to be very effective in lowering the drift. But in lidar SLAM, BA method is hardly used because the sparse feature points (e.g.,…
Millimeter wave communications rely on narrow-beam transmissions to cope with the strong signal attenuation at these frequencies, thus demanding precise beam alignment between transmitter and receiver. The communication overhead incurred to…