Related papers: Two-stage SQUID amplifier with bias current re-use
Direct-current superconducting quantum interference devices (dc-SQUIDs) are one of the most sensitive magnetic detectors. These sensors are extensively used in the readout of superconducting transition edge sensors (TESs), which are used…
Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit…
A novel topology for a high gain two-stage amplifier is proposed. The proposed circuit is designed in a way that the non-dominant pole is at output of the first stage. A positive capacitive feedback (PCF) around the second stage introduces…
A flux qubit readout scheme involving a dispersive technique coupled to a microstrip squid amplifier has been tested experimentally. Thanks to the almost quantum limited noise of this amplifier at low temperature, this readout device is…
We implement a broadly tunable phase shifter for microwaves based on superconducting quantum interference devices (SQUIDs) and study it both experimentally and theoretically. At different frequencies, a unit transmission coefficient,…
We have designed and demonstrated a Superconducting Quantum Interference Device (SQUID) array linearized with cryogenic feedback. To achieve the necessary loop gain a 300 element series array SQUID is constructed from three monolithic…
We have implemented a resonant circuit that uses a SQUID as a flux-sensitive Josephson inductor for qubit readout. In contrast to the conventional switching current measurement that generates undesired quasi-particles when the SQUID…
We developed a scanning DC SQUID microscope with novel readout electronics capable of wideband sensing RF magnetic fields from 50 to 200 MHz and simultaneously providing closed-loop response at kHz frequencies. To overcome the 20 MHz…
The present paper reports an inductor-free realization of Chua's circuit, which is designed by suitably cascading a single amplifier biquad based active band pass filter with a Chua's diode. The system has been mathematically modeled with…
We demonstrate a lumped-element Josephson parametric amplifier, using a single-ended design that includes an on-chip, high-bandwidth flux bias line. The amplifier can be pumped into its region of parametric gain through either the input…
A current bias dc SQUID behaves as an anharmonic quantum oscillator controlled by a bias current and an applied magnetic flux. We consider here its two level limit consisting of the two lower energy states $| 0 \right>$ and $| 1 \right>$.…
We present a new nanoscale superconducting quantum interference device (SQUID) whose interference pattern can be shifted electrically in-situ. The device consists of a nanoscale four-terminal/four-junction SQUID fabricated at the apex of a…
We create a Josephson parametric amplifier from a transmission line resonator whose inner conductor is made from a series SQUID array. By changing the magnetic flux through the SQUID loops, we are able to adjust the circuit's resonance…
LiteBIRD is an upcoming JAXA-led mission that aims to measure primordial gravitational waves in the B-mode polarization of the cosmic microwave background. It is set to launch in 2032. The LiteBIRD detector array consists of around 5000 TES…
A phase-bias tool, based on a trapped fluxoid in a ring, is proposed and demonstrated. It can provide arbitrary phase values and is simple to fabricate. The phase bias has been realized in two superconducting quantum interference devices,…
We propose a scheme to implement variable coupling between two flux qubits using the screening current response of a dc Superconducting QUantum Interference Device (SQUID). The coupling strength is adjusted by the current bias applied to…
We report on the fabrication and characterization of 50 Ohms, flux-tunable, low-loss, SQUID-based transmission lines. The fabrication process relies on the deposition of a thin dielectric layer (few tens of nanometers) via Atomic Layer…
We present measurements of an amplifier operating at 3.8 GHz with 150 MHz of bandwidth based on the microstrip input-coil resonance of a dc superconducting quantum interference device (SQUID) with submicron Josephson junctions. The noise…
We present a simple formalism describing evolution of a qubit in the process of its measurement in a circuit QED setup. When a phase-sensitive amplifier is used, the evolution depends on only one output quadrature, and the formalism is the…
We present measurements of an amplifier based on a dc superconducting quantum interference device (SQUID) with submicron Al-AlOx-Al Josephson junctions. The small junction size reduces their self-capacitance and allows for the use of…