Related papers: Anomalous Frequency Noise from the Megahertz Chann…
A wide variety of applications of microwave cavities, such as measurement and control of superconducting qubits, magnonic resonators, and phase noise filters, would be well served by having a highly tunable microwave resonance. Often this…
Decentralized diagnostic testing that is accurate, portable, quantitative, and capable of making multiple simultaneous measurements of different biomarkers at the point-of-need remains an important unmet need in the post-pandemic world.…
The Simons Array (SA) project is a ground-based Cosmic Microwave Background (CMB) polarization experiment. The SA observes the sky using three telescopes, and POLARBEAR-2A (PB-2A) is the receiver system on the first telescope. For the…
Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90G Hz) using a superconductor-insulator-superconductor tunnel junction…
We demonstrate a sub-shot-noise-limit discrimination of on-off keyed coherent signals by an optimal displacement quantum receiver in which a superconducting transition edge sensor is installed. Use of a transition edge sensor and a fiber…
A superconducting microstrip half-wavelength resonator is proposed as a suitable band-pass filter for broadband moderate spectral resolution spectroscopy for terahertz (THz) astronomy. The proposed filter geometry has a free spectral range…
We describe an on-sky demonstration of a microwave-multiplexing readout system in one of the receivers of the Keck Array, a polarimetry experiment observing the cosmic microwave background at the South Pole. During the austral summer of…
We report microwave impedance measurements of a superconductor-semiconductor hybrid nanowire device with three terminals (3T). Our technique makes use of transmission line resonators to acquire the nine complex scattering matrix parameters…
We analyze properties of bifurcation quantum detectors based on weakly nonlinear superconducting resonance circuits, in particular, with application to quantum readout. The developed quantitative description demonstrates strong influence of…
A differential frequency microwave sensor for angular displacement detection is reported. A metal strip-loaded cylindrical dielectric resonator (SLCDR) is excited with a 50 ohm microstrip transmission line through a rectangular slot made on…
Digital Frequency-Domain Multiplexing (DfMux) is a technique that uses MHz superconducting resonators and Superconducting Quantum Interference Device (SQUID) arrays to read out sets of Transition Edge Sensors. DfMux has been used by several…
We present a high-sensitivity measurement technique for mechanical nanoresonators. Due to intrinsic nonlinear effects, different flexural modes of a nanobeam can be coupled while driving each of them on resonance. This mode-coupling scheme…
In this Letter we present resonance properties in terahertz metamaterials consisting of a split-ring resonator array made from high temperature superconducting films. By varying the temperature, we observed efficient metamaterial resonance…
We studied noise properties of microwave signals transmitted through the cryogenic resonator. The experiments were performed with the 11.342 GHz sapphire loaded cavity resonator cooled to 6.2 K. Based on the measured transmission…
Precise phase control of microwaves and millimeter waves is critical for today's wireless communication and signal processing electronics. For decades, achieving even modest phase-shifting resolution has demanded a complex mix of transistor…
The extension of nonlinear spectroscopic techniques into the x-ray domain is in its infancy but holds the promise to provide unique insight into the dynamics of charges in photoexcited processes, which are of fundamental as well as applied…
TES-based bolometer and microcalorimeter arrays with thousands of pixels are under development for several space-based and ground-based applications. A linear detector response and low levels of cross talk facilitate the calibration of the…
The second generation of interferometric gravitational wave detectors are quickly approaching their design sensitivity. For the first time these detectors will become limited by quantum back-action noise. Several back-action evasion…
We report the realization of a bonded-bridge on-chip superconducting coil and its use in impedance-matching a highly ohmic quantum dot (QD) to a $\rm{3~GHz}$ measurement setup. The coil, modeled as a lumped-element $LC$ resonator, is more…
Extraordinarily transmitting arrays are promising candidates for quasi-optical (QO) components due to their high frequency selectivity and beam scanning capabilities owing to the leaky-wave mechanism involved. We show here how by breaking…