Related papers: Low-Temperature 2D/2D Ohmic Contacts in WSe$_2$ Fi…
The contact issue for two-dimensional (2D) materials-based field-effect transistors (FETs) has drawn enormous attention in recent years. Although ohmic behavior is achieved at room temperature, the drain current of 2DFETs shifts from ohmic…
Formation of low-resistance metal contacts is the biggest challenge that masks the intrinsic exceptional electronic properties of 2D WSe2 devices. We present the first comparative study of the interfacial properties between ML/BL WSe2 and…
We show here that the regularization of the conductivity resulting from the bosonic interactions on the `insulating' (quantum disordered) side of an insulator-superconductor transition in 2D gives rise to a metal with a finite conductivity,…
Hexagonal boron nitride (h-BN) is an important insulating substrate for two-dimensional (2D) heterostructure devices and possesses high dielectric strength comparable to SiO2. Here, we report two clear differences in their physical…
Graphene-like two-dimensional (2D) materials, not only are interesting for their exotic electronic structure and fundamental electronic transport or optical properties but also, hold promises for device miniaturization down to atomic…
The discovery of graphene has ignited intensive investigation on two dimensional (2D) materials. Among them, transition metal dichalcogenide (TMDC), a typical representative, attracts much attention due to the excellent performance in field…
We demonstrated n-type and p-type carrier injections into a transition metal dichalcogenide (TMD) WSe2 using van der Waals (vdW) contacts of two-dimensional (2D) materials: graphite for an n-type contact and NbSe2 for a p-type contact.…
We report an observation of metal-insulator transition in a thin film of SnSe$_2$. The room-temperature carrier concentration of SnSe$_2$ film was increased by electrostatic doping to 1.14$\times$ 10$^{13}$ cm$^{-2}$. A crossover from…
So far, several transition metal dichalcogenides (TMDCs) based two-dimensional (2D) topological insulators (TIs) have been discovered, all of them based on a tetragonal lattice. However, in 2D crystals, the hexagonal rather than the…
A well-defined insulating layer is of primary importance in the fabrication of passive (e.g. capacitors) and active (e.g. transistors) components in integrated circuits. One of the most widely known 2-Dimensional (2D) dielectric materials…
Dielectrics are insulating materials used in many different electronic devices and play an important role in all of them. Current advanced electronic devices use dielectric materials with a high dielectric constant and avoid high leakage…
We present the first study of the intrinsic electrical properties of WS$_2$ transistors fabricated with two different dielectric environments WS$_2$ on SiO$_2$ and WS$_2$ on h-BN/SiO$_2$, respectively. A comparative analysis of the…
Two-dimensional (2D) semiconductors are promising material candidates for next-generation nanoelectronics. However, there are fundamental challenges related to their metal-semiconductor (MS) contacts which limit the performance potential…
By carefully analyzing the low temperature density dependence of 2D conductivity in undoped high mobility n-GaAs heterostructures, we conclude that the 2D metal-insulator transition in this system is a density inhomogeneity driven…
The two-dimensional (2D) material graphene is highly promising for Hall sensors due to its potential of having high charge carrier mobility and low carrier concentration at room temperature. Here, we report the scalable batch-fabrication of…
By analyzing the temperature ($T$) and density ($n$) dependence of the measured conductivity ($\sigma$) of 2D electrons in the low density ($\sim10^{11}$cm$^{-2}$) and temperature (0.02 - 10 K) regime of high-mobility (1.0 and 1.5 $\times…
Miniaturization of electronic components has led to overheating, increasing power consumption and causing early circuit failures. Conventional heat dissipation methods are becoming inadequate due to limited surface area and higher…
Two-dimensional transition metal dichalcogenides (TMDCs) have properties attractive for optoelectronic and quantum applications. A crucial element for devices is the metal-semiconductor interface. However, high contact resistances have…
Due to the chemical inertness of 2D hexagonal-Boron Nitride (h-BN), few atomic-layer h-BN is often used to encapsulate air-sensitive 2D crystals such as Black Phosphorus (BP). However, the effects of h-BN on Schottky barrier height, doping…
Electrons and holes can spontaneously form excitons and condense in a semimetal or semiconductor, as predicted decades ago. This type of Bose condensation can happen at much higher temperatures in comparison with dilute atomic gases.…