Related papers: Tensor-Decomposition-based Hybrid Beamforming Desi…
We address joint active and passive beamforming for uplink RIS-assisted multi-user multi-stream MIMO systems with joint detection. The coupled design of the receive combiner, block-diagonal user precoders, and RIS phase vector is formulated…
In this letter, we investigate the millimeter wave (mmWave) downlink multiuser multiple-input multiple-output (MU-MIMO) system, adopting the dynamic subarray architecture at the base station and considering the multi-stream communication…
The future wireless communications are expected to provide new use scenarios with emerging techniques. This paper focuses on vehicle to everything (V2X) network, where vehicles should cooperatively implement information obtaining, data…
The design of precoding plays a crucial role in achieving a high downlink sum-rate in multiuser multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems. In this correspondence, we propose a deep…
We demonstrate that separating beamforming (i.e., downlink precoding and uplink combining) and channel estimation in multi-user MIMO wireless systems incurs no loss of optimality under general conditions that apply to a wide variety of…
Conventional digital beamforming for wideband multiuser orthogonal frequency-division multiplexing (OFDM) demands numerous power-hungry components, increasing hardware costs and complexity. By contrast, the stacked intelligent metasurfaces…
Hybrid beamforming (HB) has been widely studied for reducing the number of costly radio frequency (RF) chains in massive multiple-input multiple-output (MIMO) systems. However, previous works on HB are limited to a single user equipment…
Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…
In this paper, we design the precoding matrices at the base station side and the combining matrices at the user terminal side for initial downlink synchronization in millimeter wave massive multiple-input multiple-output systems. First, we…
6G networks are expected to provide more diverse capabilities than their predecessors and are likely to support applications beyond current mobile applications, such as virtual and augmented reality (VR/AR), AI, and the Internet of Things…
We propose a novel linear minimum-mean-squared-error (MMSE) precoder design for a downlink (DL) massive multiple-input-multiple-output (MIMO) scenario. For economical and computational efficiency reasons low resolution 1-bit…
In this paper, a framework of beamspace channel estimation in millimeter wave (mmWave) massive MIMO system is proposed. The framework includes the design of hybrid precoding and combining matrix as well as the search method for the largest…
Millimeter wave (mmWave) signals experience orders-of-magnitude more pathloss than the microwave signals currently used in most wireless applications. MmWave systems must therefore leverage large antenna arrays, made possible by the…
This paper designs a novel hybrid (a mixture of analog and digital) beamforming and examines the relation between the hybrid and digital beamformings for downlink multiuser massive multiple input multiple output (MIMO) systems. We assume…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
We propose a deep learning-based method that uses spatial and temporal information extracted from the sub-6GHz band to predict/track beams in the millimeter-wave (mmWave) band. In more detail, we consider a dual-band communication system…
In this paper, we focus on the design of the hybrid analog/digital precoding in millimeter wave multiple-input multiple-output (MIMO) systems. To reduce the feedback overhead, we propose two non-uniform quantization (NUQ) codebook based…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a recently proposed highly reconfigurable architecture enabling both spatial multiplexing and beamforming in millimeter-wave (mmWave) systems. In this work, we…
This letter presents a low-complexity hybrid precoding framework for multiuser multiple-input multiple-output (MIMO) systems by leveraging a low-dimensional subspace property. Under the low-dimensional subspace perspective, we first…
Millimeter wave (mmWave) communication is a promising solution for coping with the ever-increasing mobile data traffic because of its large bandwidth. To enable a sufficient link margin, a large antenna array employing directional…