Related papers: Dielectric and structural studies of ferroelectric…
The structural, dielectric and ferroelectric properties of lead-free (Na0.5-xKxBi0.5-xLax)TiO3 powders synthesized by sol-gel self-combustion method were investigated. Rietveld refinement of Synchrotron x-ray diffraction data confirms pure…
Polycrystalline sample of (Ba_{0.90}Pb_{0.10})(Ti_{0.90}Sn_{0.10})O_3 was obtained by means of a conventional ceramic technology. The dielectric measurements were performed depending on temperature and frequency of electric measuring field.…
We report the phase diagram of (Ba1-xCax)(Zr0.1Ti0.9)O3 solid solution. It is found that substitution of smaller Ca ions for Ba ions can slightly increase the cubic-tetragonal(T) para-ferroelectric phase transition temperature and strongly…
Room temperature dielectric and magnetic properties of BiFeO$_3$ samples, co-doped with magnetic Gd and non-magnetic Ti in place of Bi and Fe, respectively, were reported. The nominal compositions of…
The normal ferroelectric to paraelectric phase transition in model ferroelectric materials such as BaTiO3 is typically characterized by a sharp, well-defined dielectric constant peak at a specific transition temperature. However, under…
(1-x)Li0.12Na0.88NbO3-xBaTiO3 (0 to x to 0.40) ferroelectric ceramics were prepared using conventional ceramics route and their phase transitional behavior is investigated by using dielectric spectroscopy. The temperature-dependent…
The dielectric properties of tantalum doped BaTi0.85Zr0.15O3 were investigated. The conventional solid state reaction method was used to make the ceramic samples. The composition was close to the pinch point of the three structure phase…
We investigate the relaxation and conduction mechanism of Ba0.90Sr0.10TiO3 (BST) ceramic, synthesized by the solid state reaction method. The dielectric and relaxation properties are analyzed in the temperature range of 380-450{\deg}C with…
A series of Pb-free ferroelectric materials Ba0.9Sr0.1Ti1-xSnxO3 (BSTS-x) with 0 < x < 0.15 was successfully prepared via solid-state reaction method. The effect of Sn substitution on the crystal structure, microstructure, dielectric…
We report on a thermal-expansion study of the ferroelectric phase transition in insulating Sr$_{1-x}$Ca$_x$TiO$_3$ ($x=0.009$) and its evolution upon increasing charge-carrier concentration up to $n\simeq 60 \times 10^{19}$cm$^{-3}$.…
A correlation between structure and vibrational properties related to a ferroelectric to paraelectric phase transition in perovskite Pb(1-x)(Na0.5Sm0.5)xTiO3 (PNST - x) polycrystalline powders is discussed. Substitution leads to reduction…
Frequency dependence of the dielectric constant of complex perovskite oxide Ba(1-x)La(x)Ti(1-x)Cr(x)O3 (BLTC) ceramics with the composition ratio 0.4<= x <= 0.7 is precisely measured in the temperature range from 20 K to 300 K, and the…
PbTiO3 has the highest tetragonal distortion (c/a=1.064) and highest spontaneous polarization among perovskite titanates. But, it is hazardous and hence one needs to reduce Pb content by substituting or reducing Pb content for use in…
The effect of Sr doping in BaTiO3 (BTO) with nominal compositions Ba0.80Sr0.20TiO3 (BSTO) have been explored in its structural, lattice vibration, dielectric, ferroelectric and electrocaloric properties. The temperature dependent dielectric…
Observations by in-situ transmission electron microscopy (TEM) reveal the changes in domains morphology in 0.885(Bi1/2Na1/2)TiO3-0.05(Bi1/2K1/2)TiO3-0.015(Bi1/2Li1/2)TiO3-0.05BaTiO3 ceramics. Evolution of the macroscopic ferroelectric…
The temperature dependence of elastic, dielectric, and piezoelectric properties of (65-x)Pb(Mg1/3Nb2/3)O3-xBaTiO335-PbTiO3 ceramics with x=0, 1, 2, 3, and 4 was investigated. Compound with x=2 was found to exhibit a large piezoelectric…
Modeling ferroelectric materials from first principles is one of the successes of density-functional theory, and the driver of much development effort, requiring an accurate description of the electronic processes and the thermodynamic…
The dispersal of high dielectric constant ferroelectric ceramic material Ba(0.7)Sr(0.3)TiO(3) (Tc~30 C) and Ba(0.88)Sr(0.12)TiO(3) (Tc~90 C) in an ion conducting polymer electrolyte (PEO:NH4I) is reported to result in an increase in the…
By using the semi-wet synthesis method, lead-free ferroelectric materials Ba0.9Sr0.1Ti1-xSnxO3 with x = 0, 0.02, 0.05, and 0.10 (abbreviated as BSTS) were prepared and their structural, electric and electrocaloric properties were…
We have measured dielectric properties of Ca$_{1+x}$Cu$_{3-x}$Ti$_4$O$_{12}$ ($x$ = 0, 0.1, 0.5, 1, 1.5, 2, 2.9 and 3), and have found that Ca$_2$Cu$_2$Ti$_4$O$_{12}$ (a composite of CaCu$_3$Ti$_4$O$_{12}$ and CaTiO$_3$) exhibits a high…