Related papers: A Bidirectional Current-Mirror Based Potentiostat …
The MIDNA application specific integrated circuits (ASICs) are a series of skipper-CCD readout chips fabricated in a 65 nm low-power CMOS process that implement a correlated double sampling signal processing chain based on dual-slope…
This paper presents the first sub-10$\mu$W, sub-0.1% total harmonic distortion (THD) sinusoidal current generator (CG) integrated circuit (IC) that is capable of 20kHz output for the bio-impedance (Bio-Z) sensing applications. To benefit…
Implantable Brain-Computer Interfaces (iBCIs) are increasingly pivotal in clinical and daily applications. However, wireless iBCIs face severe constraints in power consumption and data throughput. To mitigate these bottlenecks, we propose a…
The circuit presented in this paper aims at providing three 40 Vpp 50Hz AC voltages sources with 120-degree phase separation between them. This is a fully analogue circuit that uses standard, low-cost electronic components without resorting…
Recording reliably extracellular neural activities isan essential prerequisite for the development of bioelectronicsand neuroprosthetic applications. Recently, a fully differential,2-stage, integrating pre-amplifier was proposed for…
Spectrum sensing in cognitive radio necessitates effective monitoring of wide bandwidths, which requires high-rate sampling. Traditional spectrum sensing methods employing high-precision analog-to-digital converters (ADCs) result in…
Silicon Photo-Multipliers (SiPM) are regarded as novel photo-detectors to replace conventional Photo-Multiplier Tubes (PMTs). However, the breakdown voltage dependence on the ambient temperature results in a gain variation of $\sim$3$\%…
Asymmetrically clipped optical orthogonal frequency-division multiplexing (ACO-OFDM) is a technique that sacrifices spectral efficiency in order to transmit an orthogonally frequency-division multiplexed signal over a unipolar channel, such…
This paper describes a 8 bits, 20 Msamples/s pipeline analog-to-digital converter implemented in 0.6 \mu m CMOS technology with a total power dissipation of 75.47 mW. Circuit techniques used include a precise comparator, operational…
In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on…
A 6bit flash-ADC with 1.2GSps, wide analog bandwidth and low power, realized in a standard digital 0.13 $\mu$m CMOS copper technology is presented. Employing capacitive interpolation gives various advantages when designing for low power: no…
We propose a new method to measure the system noise temperature, $T_{\rm sys}$, using a 2-bit analog-to-digital converter (ADC). The statistics of the digitized signal in a four-level quantization brings us information about the bias…
We measure the rectified dc currents resulting when a 3-terminal semiconductor device with gate-dependent conductance is driven with an ac gate voltage. The rectified currents exhibit surprisingly complex behaviour as the dc source-drain…
One-bit analog-to-digital converter (ADC), performing signal sampling as an extreme simple comparator, is an overwhelming technology for spectrum sensing due to its low-cost, low-power consumptions and high sampling rate. In this letter, we…
This paper presents a differential 10-bit 2 MS/s successive approximation register (SAR) analog-to-digital converter (ADC) with a precision-improvement technique. The proposed method breaks the direct tradeoff between the capacitive…
A single channel 1.5GS/s 8-bit pipelined-SAR ADC utilizes a novel output level shifting (OLS) settling technique to reduce the power and enable low-voltage operation of the dynamic residue amplifier. The ADC consists of a 4-bit first stage…
CONCERTO is a millimeter-wave imaging instrument that operated on the Atacama Pathfinder Experiment (APEX) telescope from April 2021 to May 2023. Its primary scientific objectives include the study of galaxy clusters through the…
In future high-capacity wireless systems based on mmWave or massive multiple input multiple output (MIMO), the power consumption of receiver Analog to Digital Converters (ADC) is a concern. Although hybrid or analog systems with fewer ADCs…
This paper presents a dynamic predictive sampling (DPS) based analog-to-digital converter (ADC) that provides a non-uniform sampling of input analog continuous-time signals. The processing unit generates a dynamic prediction of the input…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…