Related papers: Multi-frequency Point Supported LLRF Front-end for…
We propose to achieve joint detections of frequency and direction of arrival in wideband using single sensor based on an active metasurface with programmable transmission states of pass and stop. By integrating two PIN diodes with the…
Low-noise lasers are of central importance in a wide variety of applications, including high spectral-efficiency coherent communication protocols, distributed fibre sensing, and long distance coherent LiDAR. In addition to low phase noise,…
We study frequency dependent (FD) input-output schemes for signal-recycling interferometers, the baseline design of Advanced LIGO and the current configuration of GEO 600. Complementary to a recent proposal by Harms et al. to use FD input…
Quantum noise in a model of singly resonant frequency doubling including phase mismatch and driving in the harmonic mode is analyzed. The general formulae about the fixed points and their stability as well as the squeezing spectra…
Due to the power consumption and high circuit cost in antenna arrays, the practical application of massive multiple-input multiple-output (MIMO) in the sixth generation (6G) and future wireless networks is still challenging. Employing…
To achieve multi-Gb/s data rates in 6G optical wireless access networks based on narrow infrared (IR) laser beams, a high-speed receiver with two key specifications is needed: a sufficiently large aperture to collect the required optical…
A low level radio frequency (LLRF) control system is designed and constructed at Peking University, which is for the DC-SRF photo injector operating at 2K. Besides with continuous wave (CW), the system is also reliable with pulsed RF and…
DCLS (Dalian Coherent Light Source) is an FEL (Free-Electron Laser) user facility at EUV (Extreme Ultraviolet). The primary accelerator of DCLS operates at a repetition rate of 20 Hz, and the beam is divided at the end of the linear…
A proposal for fast-switching broadband frequency-shifting technology making use of frequency conversion in a nonlinear crystal is set forth, whereby the shifting is imparted to the converted photons by creating a bank of…
To meet an ever-increasing demand of the spectrum for communication between aircraft and ground terminals, orthogonal frequency division multiplexing (OFDM) based L-band (960-1164MHz) Digital Aeronautical Communication System (LDACS) has…
LCLS-II is an X-Ray Free Electron Laser (XFEL) commissioned in 2022, being the first Continuous Wave (CW) hard XFEL in the world to come into operation. To accelerate the electron beam to an energy of $\SI{4}{\giga \eV}$, 280 TESLA type…
Frequency diverse array (FDA) differs from conventional array techniques in that it imposes an additional frequency offset (FO) across the array elements. The use of FO provides the FDA with the controllable degree of freedom in range…
Advances in power electronics have made it possible to achieve high power levels, e.g., reaching GW in grids, or alternatively high output bandwidths, e.g., beyond MHz in communication. Achieving both simultaneously, however, remains…
The measurement of the close-to-the-carrier noise of rf and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise…
Following successful design and fabrication of damped detuned structures, the R&D for the accelerating structures of the NLC/JLC linear collider project proceeded to studies of Rounded Damped Detuned Structure with curved cross section of…
A model of the CW high-power transmitter, utilizing frequency-locked magnetrons with a phase control studied initially as a prototype of controllable in phase and power an RF source for intensity-frontier superconducting linacs, was…
Integrated sensing and communication (ISAC) is a promising technology in future wireless systems owing to its efficient hardware and spectrum utilization. In this paper, we consider a multi-input multi-output (MIMO) orthogonal frequency…
In this paper, we combine communication-theoretic laws with known, practically verified results from circuit theory. As a result, we obtain closed-form theoretical expressions linking fundamental system design and environment parameters…
A noise modelling approach is proposed for bluff body wakes such as flow over a cylinder, where the primary noise source comprises large-scale coherent structures such as the vortex shedding flow feature. This phenomenon leads to Aeolian…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…