Related papers: Drawing WS2 thermal sensors on paper substrates
Liquid-phase chemical exfoliation is ideal to achieve industry scale production of two-dimensional (2D) materials for a wide range of application such as printable electronics, catalysis and energy storage. However, many impactful 2D…
Pressure is a powerful thermodynamic parameter for tuning the magnetic properties of van der Waals magnets owing to their weak interlayer bonding. However, local magnetometry measurements under high pressure still remain elusive for this…
Due to the sensitivity of the piezoelectric layer in surface acoustic wave (SAW) resonators to temperature, a method of achieving device stability as a function of temperature is required. This work presents the design, modeling and…
Uncooled InfraRed (IR) detectors have enabled the rapid growth of thermal imaging applications. These detectors are predominantly bolometers, where the heating of pixel from incoming IR radiation is read out as a resistance change. Another…
Inside all smart devices, such as smartphones or smartwatches, there are thermally sensitive resistors known as thermistors which are used to monitor the temperature of the device. These thermistors are sensitive to temperature changes near…
For modern Gas sensors, high sensitivity and low power are expected. This paper discusses design, simulation and fabrication of new Micromachined Thermal Converters (MTCs) based on GaAs developed for Gas sensors. Metal oxide gas sensors…
We investigate transport through ionic liquid gated field effect transistors (FETs) based on exfoliated crystals of semiconducting WS$_2$. Upon electron accumulation, at surface densities close to -or just larger than- 10$^{14}$ cm$^{-2}$,…
We report on the room-temperature switching of 1T-TaS2 thin-film charge-density-wave devices, using nanosecond-duration electrical pulsing to construct their time-resolved current-voltage characteristics. The switching action is based upon…
Transition-edge sensors (TESs) can be used in high-resolution photon detection, exploiting the steep slope of the resistance in the superconducting-to-normal transition edge. Normal metal bars on the TES film are commonly used to engineer…
Td-WTe2 is a topological Weyl semimetal. WTe2 in the orthorhombic structure is stable at room temperature. Elastic, electronic, bonding, and optoelectronic properties of WTe2 have been investigated in detail in this work using the density…
Two-dimensional transition metal dichalcogenides are emerging with tremendous potential in many optoelectronic applications due to their strong light-matter interactions. To fully explore their potential in photoconductive detectors, high…
Layered iridates have been the subject of intense scrutiny on account of their unusually strong spin-orbit coupling, which opens up a narrow gap in a material that would otherwise be a metal. This insulating state is very sensitive to…
A network identification by deconvolution (NID) method is applied to the thermal transient response of packaged and unpackaged microcoolers. A thin film resistor on top of the device is used as the heat source and the temperature sensor.…
Crystalline materials with ultralow thermal conductivity are highly desirable for thermoelectric applications. Many known crystalline materials with low thermal conductivity, including PbTe and Bi2Te3, possess a special kind of chemical…
A biaxial tensile device for the transport study of layered materials is described. The device is mounted on the standard 24 pin zero force connector and can be moved between various setups. The compact design of the device makes it…
Van der Waals layered chalcogenide-based flexible thermoelectric devices show great potential for applications in wearable electronics. However, materials that are both highly deformable and exhibit superior thermoelectric performance are…
The thermophysical properties of supported and free-standing nanomaterials would be different due to the substrate effect. To determine the thermophysical properties of supported 2D nanomaterials, this paper developed a two-step…
Using the Landau-Ginzburg-Devonshire phenomenological approach we explore the strain-polarization coupling in the low-dimensional van der Waals ferrielectrics. We evolve the analytical model of the piezoelectric susceptibility of the…
We report on the preparation of inks containing fillers derived from quasi-two-dimensional charge-density-wave materials, their application for inkjet printing, and the evaluation of their electronic properties in printed thin film form.…
Controlled activation of defect-bound excitonic states in two-dimensional semiconductors provides a route to isolated quantum emitters and a sensitive probe of defect physics. Here we demonstrate that \textit{in situ} high-temperature…