Related papers: A Concentration-Time Hybrid Modulation Scheme for …
Reconfigurable intelligent surface (RIS) is regarded as an important enabling technology for the sixth-generation (6G) network. Recently, modulating information in reflection patterns of RIS, referred to as reflection modulation (RM), has…
Due to high spectral efficiency and power efficiency, the continuous phase modulation (CPM) technique with constant envelope is widely used in aeronautical telemetry in strategic weapons and rockets, which are essential for national defence…
Achieving an increase in the spectral efficiency (SE) has always been a major driver in the design of communication systems. The use of MIMO techniques in mobile communications has achieved significant benefits in improving the system…
Orthogonal frequency-division multiplexing (OFD-M) and multi-cell architecture are widely adopted in current high speed train (HST) systems for providing high data rate wireless communications. In this paper, a typical multi-antenna OFDM…
In this paper, we propose three novel modulation techniques, i.e., concentration-based, molecular-type-based, and molecular-ratio-based, using isomers as messenger molecules for nano communication networks via diffusion. To evaluate…
We propose a novel hybrid mode interferometer (HMI) leveraging the interference of hybridized TE-TM modes in a silicon-on-insulator (SOI) waveguide integrated with a GeSe phase change material (PCM) layer. The SOI waveguide's dimensions are…
This paper considers base station cooperation (BSC) strategies for the uplink of a multi-user multi-cell high frequency reuse scenario where distributed iterative detection (DID) schemes with soft/hard interference cancellation algorithms…
This paper presents an improved dual channel pulse coupled neural network (IDC-PCNN) model for image fusion. The model can overcome some defects of standard PCNN model. In this fusion scheme, the multiplication rule is replaced by addition…
A second-order accurate divergence-conserving hybrid particle-in-cell code Maximus has been developed for microscopic modeling of collisionless plasmas. The main specifics of the code include a constrained transport algorithm for exact…
Traditional molecular communications via diffusion (MCvD) systems have used baseband modulation techniques by varying properties of molecular pulses such as the amplitude, the frequency of the transversal wave of the pulse, and the time…
Spectral efficiency improvement is a key focus in most wireless communication systems and achieved by various means such as using large antenna arrays and/or advanced modulation schemes and signal formats. This work proposes to further…
In this paper, we address the symbol synchronization issue in molecular communication via diffusion (MCvD). Symbol synchronization among chemical sensors and nanomachines is one of the critical challenges to manage complex tasks in the…
Increasing AI computing demands and slowing transistor scaling have led to the advent of Multi-Chip-Module (MCMs) based accelerators. MCMs enable cost-effective scalability, higher yield, and modular reuse by partitioning large chips into…
In this paper, a novel modulation scheme called set partition modulation (SPM) is proposed. In this scheme, set partitioning and ordered subsets in the set partitions are used to form codewords. We define different SPM variants and depict a…
Inter-symbol interference (ISI) with heteroscedastic, or state-dependent, noise is a defining feature of molecular communication via diffusion (MCvD). However, such noise variance dependency across ISI states has not been systematically…
We evaluate the advantages of performing cross-phase modulation (XPM) on a very-far-off-resonance atomic system. We consider a ladder system with a weak (few-photon level) control coherent field imparting a conditional nonlinear phase shift…
In the transmission of digital data at a relatively high rate over a particular band limited channel, it is normally necessary to employ an equalizer at the receiver in order to correct the signal distortion introduced by the channel .ISI…
A joint design of both sensing and communication can lead to substantial enhancement for both subsystems in terms of size, cost as well as spectrum and hardware efficiency. In the last decade, integrated sensing and communications (ISAC)…
Massive multiple input and multiple output (MIMO) systems with orthogonal frequency division multiplexing (OFDM) are foundational for downlink multi-user (MU) communication in future wireless networks, for their ability to enhance spectral…
In this letter, we consider a 3D molecular communication via diffusion system (MCvDS) with a single point transmitter and multiple fully-absorbing spherical receivers whose centers are distributed as a Poisson point process (PPP) in the…