Related papers: BiLiMO: Bit-Limited MIMO Radar via Task-Based Quan…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…
This paper presents an analysis of target localization accuracy, attainable by the use of MIMO (Multiple-Input Multiple-Output) radar systems, configured with multiple transmit and receive sensors, widely distributed over a given area. The…
One way to reduce the power consumption in large-scale multiple-input multiple-output (MIMO) systems is to employ low-resolution analog-to-digital converters (ADCs). In this paper, we investigate antenna selection for large-scale MIMO…
Beamforming techniques are proposed for a joint multi-input-multi-output (MIMO) radar-communication (RadCom) system, where a single device acts both as a radar and a communication base station (BS) by simultaneously communicating with…
We consider the problem of angle-robust joint transmit waveform and receive filter design for colocated Multiple-Input Multiple-Output (MIMO) radar, in the presence of signal-dependent interferences. The design problem is cast as a max-min…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
In multiple-antenna communications, as bandwidth and modulation order increase, system components must work with demanding tolerances. In particular, high resolution and high sampling rate analog-to-digital converters (ADCs) are often…
A novel dynamic hybrid beamforming architecture is proposed to achieve the spatial multiplexing-power consumption tradeoff for near-field multiple-input multiple-output (MIMO) networks, where each radio frequency (RF) chain is connected to…
A joint robust transmit/receive adaptive beamforming for multiple-input multipleoutput (MIMO) radar based on probability-constrained optimization approach is developed in the case of Gaussian and arbitrary distributed mismatch present in…
We consider the weak target detection problem with unknown parameter in colocated multiple-input multiple-output (MIMO) radar. To cope with the sheer amount of data for large-size systems, a multi-bit quantizer is utilized in the sampling…
Accurate reconstruction of static and rapidly moving targets demands three-dimensional imaging solutions with high temporal and spatial resolution. Radar sensors are a promising sensing modality because of their fast capture rates and their…
Despite an emerging interest in MIMO radar, the utilization of its complementary strengths in combination with optical depth sensors has so far been limited to far-field applications, due to the challenges that arise from mutual sensor…
Low resolution analog-to-digital converters (ADCs) can be employed to improve the energy efficiency (EE) of a wireless receiver since the power consumption of each ADC is exponentially related to its sampling resolution and the hardware…
This paper focuses on the joint design of transmit waveforms and receive filters for airborne multiple-input-multiple-output (MIMO) radar systems in spectrally crowded environments. The purpose is to maximize the output…
This paper focuses on radar waveform optimization for minimizing the Cram\'er-Rao bound (CRB) in a multiple-input multiple-output (MIMO) radar system. In contrast to conventional approaches relying on semi-definite programming (SDP) and…
We analyze a multiple-input multiple-output (MIMO) radar model and provide recovery results for a compressed sensing (CS) approach. In MIMO radar different pulses are emitted by several transmitters and the echoes are recorded at several…
In this paper, colocated MIMO radar waveform design is considered by minimizing the integrated side-lobe level to obtain beam patterns with lower side-lobe levels than competing methods. First, a quadratic programming problem is formulated…
Multiple-input multiple-output (MIMO) radar has several advantages with respect to the traditional radar array systems in terms of performance and flexibility. However, in order to achieve high angular resolution, a MIMO radar requires a…
One of the basic aspects of Massive MIMO (MaMi) that is in the focus of current investigations is its potential of using low-cost and energy-efficient hardware. It is often claimed that MaMi will allow for using analog-to-digital converters…