Related papers: Deep Analog-to-Digital Converter for Wireless Comm…

The use of low-resolution analog-to-digital converters (ADCs) can significantly reduce power consumption and hardware cost. However, their resulting severe nonlinear distortion makes reliable data transmission challenging. For orthogonal…

We propose a fast and near-optimal approach to joint channel-estimation, equalization, and decoding of coded single-carrier (SC) transmissions over frequency-selective channels with few-bit analog-to-digital converters (ADCs). Our approach…

With the advancement in the field of the Internet of Things(IoT) and Internet of Bodies(IoB), video camera applications using Video Sensor Nodes(VSNs) have gained importance in the field of autonomous driving, health monitoring, robot…

The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…

Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…

Motivated by the practical constraints arising in emerging sensor network and Internet-of-Things (IoT) applications, the zero-delay transmission of a Gaussian measurement over a real single-input multiple-output (SIMO) additive white…

This paper presents the new approach in implementation of analog-to-digital converter (ADC) that is based on Hopfield neural-network architecture. Hopfield neural ADC (NADC) is a type of recurrent neural network that is effective in solving…

Analog to digital conversion is a very important part of almost all beam instrumentation systems. Ideally, in a properly designed system, the used analog to digital converter (ADC) should not limit the system performance. However, despite…

Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…

Large-scale multiple-antenna systems with large bandwidth are fundamental for future wireless communications, where the base station employs a large antenna array. In this scenario, one problem faced is the large energy consumption as the…

An ADC is used to convert analog signals into binary signals. Compared with many other types of ADCs, flash converters are incredibly quick. A typical Flash ADC consists of 2n resistors, 2n-1 op-amp comparators, and an encoder which…

Timing systems based on Analog-to-Digital Converters are widely used in the design of previous high energy physics detectors. In this paper, we propose a new method based on deep learning to extract the time information from a finite set of…

Obtaining digital representations of multivariate continuous-time (CT) signals is a challenge encountered in many signal processing systems. In practice, these signals are often acquired to extract some underlying information, i.e., for a…

We investigate the uplink throughput achievable by a multiple-user (MU) massive multiple-input multiple-output (MIMO) system in which the base station is equipped with a large number of low-resolution analog-to-digital converters (ADCs).…

Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…

Motivated by the demand for energy-efficient communication solutions in the next generation cellular network, a mixed-ADC architecture for massive multiple input multiple output (MIMO) systems is proposed, which differs from previous works…

The edge processing of deep neural networks (DNNs) is becoming increasingly important due to its ability to extract valuable information directly at the data source to minimize latency and energy consumption. Frequency-domain model…

Low-resolution digital-to-analog converters (DACs) and analog-to-digital converters (ADCs) are considered to reduce cost and power consumption in multiuser massive multiple-input multiple-output (MIMO). Using the Bussgang theorem, we derive…

The proliferation of networked devices and the surging demand for ubiquitous intelligence have given rise to the artificial intelligence of things (AIoT). However, the utilization of high-resolution analog-to-digital converters (ADCs) and…

Despite the intensive recent research on wireless single-channel full-duplex communications, relatively little is known about the transceiver chain nonidealities of full-duplex devices. In this paper, the effect of nonlinear distortion…