Related papers: Adaptive Distributed Transceiver Synchronization O…
In this paper, a novel and robust algorithm is proposed for adaptive beamforming based on the idea of reconstructing the autocorrelation sequence (ACS) of a random process from a set of measured data. This is obtained from the first column…
Wireless power transfer (WPT) technologies hold promise for enhancing device autonomy, particularly for energy-limited IoT systems. This paper presents experimental results on coherent and non-coherent transmit diversity approaches for WPT,…
In traditional spread-spectrum techniques, a wideband transmit signal is obtained by modulating a wideband carrier by a narrowband signal containing a relatively low-rate message. In the receiver, the respective demodulation/despreading…
This paper studies a sub-connected six-dimensional movable antenna (6DMA)-aided multi-user communication system. In this system, each sub-array is connected to a dedicated radio frequency chain and collectively moves and rotates as a unit…
Terahertz (THz) communications are envisioned as a key technology of next-generation wireless systems due to its ultra-broad bandwidth. One step forward, THz integrated sensing and communication (ISAC) system can realize both unprecedented…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
High-performance phase control units are crucial in beamforming technology, which has gained substantial attention for its ability to manipulate the wireless propagation environment, thereby enhancing capacity and coverage in communication…
Multiple transmitting antennas can considerably increase the downlink spectral efficiency by beamforming to multiple users at the same time. However, multiuser beamforming requires channel state information (CSI) at the transmitter, which…
Intelligent reflecting surface (IRS) is a promising technology for achieving high spectrum efficiency in future wireless networks by leveraging massive low-cost reflecting elements with each reflecting the incident signal with a proper…
Integrated Sensing and Communication (ISAC) has attracted substantial attraction in recent years for spectral efficiency improvement, enabling hardware and spectrum sharing for simultaneous sensing and signaling operations. In-band Full…
A novel approach is suggested for improving the accuracy of fault detection in distribution networks. This technique combines adaptive probability learning and waveform decomposition to optimize the similarity of features. Its objective is…
Millimeter-wave (mm-Wave) cellular systems are a promising option for a very high data rate communication because of the large bandwidth available at mm-Wave frequencies. Due to the large path-loss exponent in the mm-Wave range of the…
The evolution of wireless communication systems towards millimeter-wave ($30-100$ GHz) and sub-THz ($>100$ GHz) frequency bands highlighted the need for accurate and fast beam management and a proactive link-blockage prediction in…
Integrated sensing and communication (ISAC) in the near-field regime offers the potential to jointly support high-rate downlink transmission and high-resolution multi-target detection by exploiting the spherical-wave nature of…
Millimeter wave (mmWave) cellular systems will enable gigabit-per-second data rates thanks to the large bandwidth available at mmWave frequencies. To realize sufficient link margin, mmWave systems will employ directional beamforming with…
This paper studies a three-node network in which an intermediate nano-transceiver, acting as a relay, is placed between a nano-transmitter and a nano-receiver to improve the range of diffusion-based molecular communication. Motivated by the…
The highly sparse nature of propagation channels and the restricted use of radio frequency (RF) chains at transceivers limit the performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. Introducing…
At millimeter wave (mmWave) frequencies, the higher cost and power consumption of hardware components in multiple-input multiple output (MIMO) systems do not allow beamforming entirely at the baseband with a separate radio frequency (RF)…
This paper addresses the challenge of network synchronization under limited communication, involving heterogeneous agents with different dynamics and various network topologies, to achieve consensus. We investigate the distributed adaptive…
Energy beamforming (EB) is a key technique for achieving efficient radio-frequency (RF) transmission enabled wireless energy transfer (WET). By optimally designing the waveforms from multiple energy transmitters (ETs) over the wireless…