Related papers: Heat-capacity measurements under uniaxial pressure…
We studied the pressure-induced superconductor CeIrSi$_3$ with the non-centrosymmetric tetragonal structure under high pressure. The electrical resistivity and ac heat capacity were measured in the same run for the same sample. The critical…
We study an Otto heat machine whose working substance is a single two-level system interacting with a cold thermal reservoir and with a squeezed hot thermal reservoir. By adjusting the squeezing or the adiabaticity parameter (the…
We have investigated uniaxial and hydrostatic pressure effects on superconductivity in Fe1.07Te0.88S0.12 through magnetic-susceptibility measurements down to 1.8 K. The superconducting transition temperature Tc is enhanced by out-of-plane…
We have measured the specific heat and magnetization {\it versus} temperature in a single crystal sample of superconducting La$_{2}$CuO$_{4.11}$ and in a sample of the same material after removing the excess oxygen, in magnetic fields up to…
The investigations of low-temperature heat capacity in pure and impurity doped high temperature superconductors have been performed by high-precision pulsed differential scanning calorimeter, providing the measurements of heat capacities…
We introduce a nanocalorimetric technique based on microsecond-pulsed heating (\mu s-PHnC) that enables high-sensitivity, quasi-isothermal heat capacity measurements on nanoscale samples. Such resolution is critical for exploring…
We describe a set-up for studying adsorption of helium in silica aerogels, where the adsorbed amount is easily and precisely controlled by varying the temperature of a gas reservoir between 80 K and 180 K. We present validation experiments…
The room-temperature longitudinal piezoresistance of n-type and p-type crystalline silicon along selected crystal axes is investigated under uniaxial compressive stresses up to 3 GPa. While the conductance ($G$) of n-type silicon eventually…
A new method of absolute heat capacity measurement was developed in the Department of Biological Systems Physics at the E. Andronikashvili Institute of Physics, Georgian Academy of Sciences. This is the method of absolute heat capacity…
We describe a simple AC susceptometer built in-house that can be used to make high-resolution measurements of the magnetic susceptibility of high-temperature superconductors in an undergraduate physics lab. Our system, cooled using liquid…
Superconductivity with Tc of 45 K was realized in the tetragonal ZrCuSiAs-type PrOxFeAs (x=0.75) under heat treatment of 1300 oC and pressure of 6 GPa for 2 hours. Although the sample prepared at 900 oC in vaccum possessed the same phase as…
Integrating multiple sensing capabilities into a single multimodal sensor greatly enhances its applications for in-situ sensing and structural health monitoring. However, the fabrication of multimodal sensors is complicated and limited by…
When a gas in an externally imposed potential field is compressed, temperature gradients appear. This has been called the piezothermal effect. It is possible to analytically calculate the time-dependent behavior of the piezothermal effect…
We present a 3 omega method for simultaneously measuring the specific heat and thermal conductivity of a rod- or filament-like specimen using a way similar to a four-probe resistance measurement. The specimen in this method needs to be…
A commercially available calorimeter has been used to investigate the specific heat of a high-quality \kn\ single crystal. The addenda heat capacity of the calorimeter is determined in the temperature range $0.02 \, \mathrm{K} \leq T \leq…
Samples of heavy fermion compound CeCu6 were prepared by hot-press technique. Temperature-dependent (5-300 K) thermoelectric transport properties of the samples were measured. The dimensionless figure-of-merit (ZT) was optimized by varying…
The pressure dependence of superconducting transition temperature $T_{\rm c}$ has been investigated through the DC magnetic measurements for FeSe$_{0.8}$ and FeSe$_{1.0}$. For both samples, with increasing pressure $P$, the $T_{\rm…
An experimental setup was developed for the measurement of the thermoelectric power (TEP, Seebeck coefficient) in the temperature range from 2 to 350 K and magnetic fields up to 140 kOe. The system was built to fit in a commercial cryostat…
Superconductors with low superfluid density can be described by XY models. In such models the scale of the transition temperature T_c is largely set by the zero temperature phase stiffness (helicity modulus), a long-wavelength property of…
Earlier studies show that organic and inorganic semiconducting materials are the most promising materials for use in temperature sensors. In this brief review, attention will be focused on temperature sensors and its applications in various…