Related papers: Scheme for a 50 TeV muon accumulator
We show that Compton scattering can be used to cool TeV-scale muon beams, and we derive analytical expressions for the equilibrium transverse angular spread, longitudinal energy spread, and power requirements. We find that a factor of a few…
A muon collider represents the ideal machine to reach very high center-of-mass energies and luminosities by colliding elementary particles. This is the result of the low level of beamstrahlung and synchrotron radiation compared to linear or…
The investigation of the energy frontier in physics requires novel concepts for future colliders. The idea of a muon collider is very appealing since it would allow to study particle collisions at up to tens of TeV energy, while offering a…
One of the challenge of future muon colliders is the production of muon beams carrying high phase space densities. In particular the muon beam normalised transverse emittance is a relevant figure of merit to meet luminosity requests. A…
We propose a novel scheme for final muon ionization cooling with quadrupole doublets followed by emittance exchange in vacuum to achieve the small beam sizes needed by a muon collider. A flat muon beam with a series of quadrupole doublet…
It is shown that at a 100 TeV muon collider the synchrotron radiation in the ring will determine the minimum horizontal emittance.
KEK-ATF is studying the low-emittance multi-bunch electron beam for the future linear collider. In ATF, thermionic gun is used to generate 20 bunches electron beam with the bunch spacing of 2.8 ns. Due to a distortion of the gun emission…
Low energy muon experiments such as mu2e and g-2 have a limited energy spread acceptance. Following techniques developed in muon cooling studies and the MICE experiment, the number of muons within the desired energy spread can be increased…
A muon storage ring neutrino source uses an induction linac for muon capture, a 200 MHz copper cavity system for cooling, and 200 and 400 MHz superconducting rf systems for acceleration to a final energy of up to 50 GeV. These systems and…
We present a scheme for producing intense $\mu^+$ and $\mu^-$ lepton beams that could be utilized in a future muon-muon or muon-ion collider, as well as for other applications. The scheme makes use of BACKscattered GAMMas On Nucleons…
An ion beam cooler and buncher has been developed for the manipulation of radioactive ion beams. The gas-filled linear radiofrequency ion trap system is installed at the Penning trap mass spectrometer ISOLTRAP at ISOLDE/CERN. Its purpose is…
A high-energy muon collider scenario requires a final cooling system that reduces transverse emittance to ~25 microns (normalized) while allowing longitudinal emittance increase. Ionization cooling using high-field solenoids (or Li Lens)…
On-line monitoring of beam quality for high brightness beams is only possible using non-invasive instruments. For matching measurements, very few such instruments are available. One candidate is a quadrupole pick-up. Therefore, a new type…
An intense beam of muons is needed to provide a luminosity on the order of 10$^{34}$ cm$^{-2}$s$^{-1}$ for a multi-TeV collider. Because muons produced by colliding a multi-MW proton beam with a target made of carbon or mercury have a large…
High luminosity in DAFNE needs very high electron and positron currents stored. A full energy (510 MeV) injection system composed by a full energy electron and positron linac and an accumulator-damping ring is presently used. The electron…
Present availability of high brilliance photon beams as those produced by X-ray Free Electron Lasers in combination with intense TeV proton beams typical of the Large Hadron Collider makes it possible to conceive the generation of pion…
New self-consistent parameter sets are presented and discussed for muon collider rings at center-of-mass energies of 10, 30 and 100 TeV. All three parameter sets attain luminosities of 3 x 10^35 /cm^2/s. The parameter sets benefit from new…
We propose a new beam dump experiment at a future TeV-scale muon collider. A beam dump would be an economical and effective way to increase the discovery potential of the collider complex in a complementary regime. In this work we consider…
The International Muon Collider Collaboration (IMCC) is engaged in a design study for a future facility intended to collide muons. Subsequent to the initial linear acceleration, the counter-rotating muons and anti-muons are accelerated in a…
A high-energy muon collider scenario require a "final cooling" system that reduces transverse emittance by a factor of ~10 while allowing longitudinal emittance increase. The baseline approach has low-energy transverse cooling within…