Related papers: Flame/flow dynamics at the piston surface of an IC…
Understanding the detailed flame transport in IC engines is important to predict ignition, rate of heat release and assess engine performance. This is particularly important for RANS and LES engine simulations, which often struggle to…
The study of turbulent boundary layer flow holds significant importance in urban climate research, particularly concerning numerical simulation studies where it serves as a crucial inflow boundary condition. However, understanding the…
This study introduces a novel experimental configuration using OH-PLIF imaging to directly determine the stretch factor ($I_0$) in laminar premixed hydrogen flames transitioning from a quasi-stable to a thermodiffusively unstable regime. A…
Design of efficient, downsized piston engines requires an understanding of transient wall heat losses. Measurements of the spatially and temporally evolving thermal boundary layer (TBL) are required to facilitate this knowledge. This work…
Reactive flows in confined spaces involve complex flame-wall interaction (FWI). This work aims to gain more insights into the physics of the premixed near-wall flame and the wall heat flux as an important engineering relevant quantity. Two…
Modern diesel engines temporarily use a very late post-injection in the combustion cycle to either generate heat for a diesel particulate filter regeneration or purge a lean NOx trap. In some configurations, unburned fuel is left at the…
The development of thermal boundary layers and plume near a section-triangular roof under different isothermal heating conditions have been the focus of numerous numerical studies. However, flow transition in this type of flow has never…
The ability of computational fluid dynamics (CFD) models to predict flow boiling at high heat flux and high flow velocity conditions has been investigated. High heat fluxes of about 10 MW/m 2 and high flow velocities of about 10 m/s…
Cyclic-to-cycle variability, CCV, of intake-jet flow in an optical engine was measured using particle image velocimetry (PIV), revealing the possibility of two different flow patterns. A phase-dependent proper orthogonal decomposition (POD)…
This paper reports theoretical and numerical investigations on free molecular gas flows through micro-channels. Both diffusely and specularly reflective channel surfaces are considered. Gaskinetic methods are adopted to develop the…
Determination of heat transfer coefficients for flowing packed particle beds is essential to the design of particle heat exchangers, and other thermal processes. While such dense granular flows fall into the well-known plug-flow regime, the…
Iron dust counter-flow flames have been studied with the low-Mach-number combustion approximation. The model considers full coupling between the two phases, including particle/droplet drag. The dispersed phase flow strain relations are…
This paper investigates the steady axisymmetric structure of the cold boundary-layer flow surrounding fire whirls developing over localized fuel sources lying on a horizontal surface. The inviscid swirling motion found outside the boundary…
Airflow simulation results depend on a good prediction of near wall turbulence. In this paper a comparative study between different near wall treatments is presented. It is applied to two test cases: (1) the first concerns the fully…
The present work details the analysis of the aerodynamics of an experimental swirl stabilized burner representative of gas turbine combustors. This analysis is carried out using High Frequency PIV (HFPIV) measurements in a reactive…
Flame propagation through a non-volatile solid-fuel suspension is studied using a simplified, time-dependent numerical model that considers the influence of both diffusional and kinetic rates on the particle combustion process. It is…
This study investigates the effect of increasing strain rate on thermodiffusively unstable, lean premixed hydrogen flames in a 2D counterflow configuration through detailed-chemistry numerical simulations for the first time. The analysis of…
Emerging commercial and academic tools are regularly being applied to the design of road and race cars, but there currently are no well-established benchmark cases to study the aerodynamics of race car wings in ground effect. In this paper…
The exhaust flow of a Pulse Detonation Combustor (PDC) is investigated for different operating conditions. The PDC consists of two units, the deflagration to detonation transition section and the exhaust tube with a straight nozzle.…
Atmosphere-breathing electric propulsion systems harness atmospheric particles as propellant, enabling efficient operation across diverse environmental conditions. To accurately simulate the captured gas flow through the modules,…