Related papers: An Approximate Maximum Likelihood Time Synchroniza…
The discussion on using zero padding (ZP) instead of a cyclic prefix (CP) for enhancing channel estimation and equalization performance is a recurring topic in waveform design for future wireless systems that high spectral efficiency and…
Existing Orthogonal Frequency-Division Multiplexing (OFDM) variants based on cyclic prefix (CP) allow for efficient time synchronization, but suffer from lower power efficiency compared to zero-padded (ZP)-OFDM. Because of its power…
Orthogonal Frequency Division Multiplexing (OFDM) has recently been applied in wireless communication systems due to its high data rate transmission capability with high bandwidth efficiency and its robustness to multi-path delay. Fading is…
In this paper synchronization techniques using cyclic prefix (CP) are analyzed to remove the influence of symbol time offset (STO) for correct synchronization in Orthogonal Frequency Division Multiplex (OFDM) system. For correct detection…
Recently, a new precoding technique called orthogonal time-frequency signaling (OTFS) has been proposed for time- and frequency-selective communication channels. OTFS precodes a data frame with a complete set of spreading sequences and…
We propose a novel receiver for orthogonal frequency division multiplexing (OFDM) transmissions in impulsive noise environments. Impulsive noise arises in many modern wireless and wireline communication systems, such as Wi-Fi and powerline…
Visible light communications (VLC) have recently attracted a growing interest and can be a potential solution to realize indoor wireless communication with high bandwidth capacity for RF-restricted environments such as airplanes and…
Future wireless communication systems must simultaneously address multiple challenges to ensure accurate data detection, deliver high Quality of Service (QoS), adding enable a high data transmission with low system design. Additionally,…
In this paper, a novel technique is proposed to address the joint sampling timing acquisition for baseband and broadband power-line communication (BB-PLC) systems using Orthogonal-Frequency-Division-Multiplexing (OFDM), including the…
A telecommunication system uses carriers in order to transmit information through a cable or wirelessly. If each time only one carrier is transmitted, then the system s signal will not be immune to frequency selective fading. If frequency…
In this paper, we propose a novel estimator for pilot-aided orthogonal frequency division multiplexing (OFDM) channels in an additive Gaussian and impulsive perturbation environment. Due to sensor failure which might happen because of…
Orthogonal Frequency Division Multiplexing (OFDM) is a transmission technique that uses several subcarrier frequencies (multicarrier) that are perpendicular to each other (orthogonal). This OFDM modulation technique effectively eliminates…
Orthogonal frequency division multiplexing (OFDM) is one of the dominant waveforms in wireless communication systems due to its efficient implementation. However, it suffers from a loss of spectral efficiency as it requires a cyclic prefix…
Wireless communication is the most effective communication to convey audio or video information among the population. It enables the masses to connect throughout the world. Wireless technologies improve the lifestyle of individuals in rural…
Orthogonal frequency-division multiplexing (OFDM) is a promising waveform candidate for future joint sensing and communication systems. It is well known that the OFDM waveform is vulnerable to in-phase and quadrature-phase (IQ) imbalance,…
Phase noise correction is crucial to exploit full advantage of orthogonal frequency division multiplexing (OFDM) in modern high-data-rate communications. OFDM channel estimation with simultaneous phase noise compensation has therefore drawn…
Multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) is a key technology component in the evolution towards cognitive radio (CR) in next-generation communication in which the accuracy of timing and frequency…
Polynomial-cancellation-coded orthogonal frequency division multiplexing (PCC-OFDM) is a form of OFDM that has waveforms which are very well localized in both the time and frequency domains and so it is ideally suited for use in the 5G…
The demand for high-speed mobile wireless communications is rapidly growing. Orthogonal Frequency Division Multiplexing (OFDM) technology promises to be a key technique for achieving the high data capacity and spectral efficiency…
One of the most important multi-carrier transmission techniques used in the latest wireless communication arena is known as Orthogonal Frequency Division Multiplexing (OFDM). It has several characteristics such as providing greater immunity…