Related papers: Turbo Coded Single User Massive MIMO with Precodin…
Aiming at maximizing the achievable sum-rate of wideband multiuser mmWave massive MIMO systems, the hybrid precoding is studied. Since each computation of the achievable sum-rate can be performed only after the analog precoder and digital…
Tomlinson-Harashima precoding (THP) is a nonlinear processing technique employed at the transmit side and is a dual to the successive interference cancelation (SIC) detection at the receive side. Like SIC detection, the performance of THP…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) has been regarded to be an emerging solution for the next generation of communications, in which hybrid analog and digital precoding is an important method for reducing…
Hybrid analog-digital precoding significantly reduces the hardware costs in massive MIMO transceivers when compared to fully-digital precoding at the expense of increased transmit power. In order to mitigate the above shortfall, we use the…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
Neural networks have been applied to the physical layer of wireless communication systems to solve complex problems. In millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems, hybrid precoding has been considered as…
We consider downlink precoding in a frequency-selective multi-user Massive MIMO system with highly efficient but non-linear power amplifiers at the base station (BS). A low-complexity precoding algorithm is proposed, which generates…
In this paper, we investigate the design of linear precoders for multiple-input multiple-output (MIMO) multiple access channels (MAC). We assume that statistical channel state information (CSI) is available at the transmitters and consider…
In future practical deployments of massive multi-input multi-output (MIMO) systems, the number of radio frequency (RF) chains at the base stations (BSs) may be much smaller than the number of BS antennas to reduce the overall expenditure.…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
In this paper, we address the transmit antenna selection in multi-user MIMO systems with precoding. The optimum and reduced complexity sub-optimum antenna selection algorithms are introduced. QR-decomposition (QRD) based antenna selection…
Precoding with block diagonalization is an attractive scheme for approaching sum capacity in multiuser multiple input multiple output (MIMO) broadcast channels. This method requires either global channel state information at every receiver…
This paper presents an energy-efficient downlink precoding scheme with the objective of maximizing system energy efficiency in a multi-cell massive MIMO system. The proposed precoding design jointly considers the issues of power control,…
The throughput of users with poor channel conditions, such as those at a cell edge, is a bottleneck in wireless systems. A major part of the power budget must be allocated to serve these users in guaranteeing their quality-of-service (QoS)…
We propose an algorithm for joint precoding and user selection in multiple-input multiple-output systems with extremely-large aperture arrays, assuming realistic channel conditions and imperfect channel estimates. The use of long-term…
The next generation of wireless communications systems will employ new frequency bands such as those in the upper midband, millimeter-wave and sub-terahertz frequency bands. The high energy consumption of analog-to-digital converters…
We apply the replica method to analyze vector precoding, a method to reduce transmit power in antenna array communications. The analysis applies to a very general class of channel matrices. The statistics of the channel matrix enter the…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
We present and analyze the performance of constellation precoded beamforming. This multi-input multi-output transmission technique is based on the singular value decomposition of a channel matrix. In this work, the beamformer is precoded to…
Reciprocity-based time-division duplex (TDD) Massive MIMO (multiple-input multiple-output) systems utilize channel estimates obtained in the uplink to perform precoding in the downlink. However, this method has been criticized of breaking…