Related papers: Melting and crystallization in layered film system…
Post deposition variation in film resistance of Sb2Te3 films deposited on glass substrates at room temperature and an elevated temperature (110oC) are investigated. The resistance of films grown at room temperature shows a non-linear…
Understanding the wetting properties of premelting films requires knowledge of the film's equation of state, which is not usually available. Here we calculate the disjoining pressure curve of premelting films, and perform a detailed…
Among the several flexible thermoelectric modules in existence, sintered Bi-Te-based modules represent a viable option because of their high output power density and flexibility, which enables the use of arbitrary heat sources. We have…
Dewetting of thin polystyrene films deposited onto silicone wafers at temperatures close to the glass transition exhibits unusual dynamics and front morphologies. Here, we present a new theoretical approach of these phenomena taking into…
Single crystals of K$_x$Fe$_{2-y}$Se$_2$ are prepared by quenching at various temperatures. The crystals obtained at higher quenching temperatures have a surface morphology with mesh-like texture. They show a sharp superconducting…
Thermoelectric materials allow the direct conversion of waste heat into electricity, and novel materials are being investigated for this purpose. Recently, doped Bi$_2$O$_2$Se has shown high application potential. In this study, we discuss…
Melting is typically viewed as a bulk first-order phase transition that proceeds once nucleation barriers are overcome. Here we demonstrate an interfacially arrested melting regime in molecularly thin crystalline films, where large liquid…
Dielectric relaxation and thermal expansion spectroscopy were made for thin polystyrene films in order to measure the temperature $T_{\alpha}$ corresponding to the peak in the loss component of susceptibility due to the $\alpha$-process and…
Laser ablation of Al-Ni alloys and Al films on Ni substrates has been studied by molecular dynamics simulations (MD). The MD method was combined with a two-temperature model to describe the interaction between the laser beam, the electrons…
In this paper we report a new sol-gel method for the fabrication of MgB2 films. Polycrystalline MgB2 films were prepared by spin-coating a precursor solution of Mg(BH_4)_2 diethyl ether on (001)Al2O3 substrates followed with annealing in Mg…
X-ray measurements reveal a crystalline monolayer at the surface of the eutectic liquid Au_{82}Si_{18}, at temperatures above the alloy's melting point. Surface-induced atomic layering, the hallmark of liquid metals, is also found below the…
In order to investigate the effects of in-plane strain on the superconductivity of FeSe, epitaxial thin films of FeSe were fabricated on CaF$_2$ substrates. The films are compressed along the a-axis and their superconducting transition…
This article introduces a thin-film thermocouple temperature sensor with symmetrical electrode structure. It uses PI film as a flexible substrate. Cu film and CuNi film made by MEMS manufacturing process as positive and negative electrodes.…
We present a modified simulated annealing method with a dynamical choice of the cooling temperature. The latter is determined via a closed-loop control and is proven to yield exponential decay of the entropy of the particle system. The…
We discuss the crystallization process from the supersaturated melt in terms of its non-equilibrium properties. In particular, we quantify the amount of heat that is produced irreversibly when a suspension of hard spheres crystallizes. This…
Quantum simulations of vestigial orders in multi-orbital superfluids have been attracting continuous research interests in both cold atoms and condensed matter systems, as it provides valuable insights into the high-temperature…
Supercooling of water can be easily studied with a simple apparatus suitable for the student laboratory. We describe such an apparatus and its capabilities. The parameters influencing supercooling include the initial temperature of the…
We report bcc-like crystal structures in 2-4 ML Fe films grown on fcc Cu(100) using scanning tunneling microscopy. The local bcc structure provides a straightforward explanation for their frequently reported outstanding magnetic properties,…
At temperatures well below their glass transition, the deformation properties of bulk metallic glasses are characterised by a sharp transition from elasticity to plasticity, a reproducible yield stress, and an approximately linear decrease…
We describe a simple model for the melting and optical properties of a DNA/gold nanoparticle aggregate. The optical properties at fixed wavelength change dramatically at the melting transition, which is found to be higher and narrower in…