Related papers: Towards Direct Numerical Simulation of a 5x5 Rod B…
We put forward a new type of spectral method for the direct numerical simulation of flows where anisotropy or very fine boundary layers are present. The mean idea is to take advantage of the fact that such structures are dissipative and…
Microvortex generators are passive control devices smaller than the boundary layer thickness that energise the boundary layer to prevent flow separation with limited induced drag. In this work, we use direct numerical simulations (DNSs) to…
This chapter provides an introduction to data-driven techniques for the development and calibration of closure models for the Reynolds-Averaged Navier--Stokes (RANS) equations. RANS models are the workhorse for engineering applications of…
Modeling of fluid flows requires corresponding adequate and effective approaches that would account for multiscale nature of the considered physics. Despite the tremendous growth of computational power in the past decades, modeling of fluid…
A numerical investigation of the flow evolution over a pitching NACA 0012 airfoil incurring in deep dynamic stall phenomena is presented. The experimental data at Reynolds number Re = 135 000 and reduced frequency k = 0.1, provided by Lee…
Two-way coupled DNS simulation of particle-laden turbulent Couette-flow [1], in the volume fraction regime $\phi>10^{-4}$, showed a discontinuous decrease of turbulence intensity beyond a critical volume fraction…
This work presents a high-fidelity computational fluid dynamics (CFD) and data-driven modeling framework for assembly-level flow characterization in a four-loop pressurized water reactor (PWR). A full lower-plenum and core-inlet domain was…
The paper presents the results of computation of some simple internal flows of incompressible fluid with the software package CFX-5. In the previous paper of the author, the same flows were used for testing of another CFD software tool,…
The local streamline topology classification method of Chong et al. (1990) is adapted and extended to describe the geometry of infinitesimal vortex lines. Direct numerical simulation (DNS) data of forced isotropic turbulence reveals that…
The efficient mixing of fluids is key in many applications, such as chemical reactions and nanoparticle precipitation. Detailed experimental measurements of the mixing dynamics are however difficult to obtain, and so predictive numerical…
Fully-convolutional neural networks (FCN) were proven to be effective for predicting the instantaneous state of a fully-developed turbulent flow at different wall-normal locations using quantities measured at the wall. In Guastoni et al.…
Flows through medical devices as well as in anatomical vessels despite being at moderate Reynolds number may exhibit transitional or even turbulent character. In order to validate numerical methods and codes used for biomedical flow…
Fluid thermodynamics underpins atmospheric dynamics, climate science, industrial applications, and energy systems. However, direct numerical simulations (DNS) of such systems can be computationally prohibitive. To address this, we present a…
We conduct depth-resolved three-dimensional Direct Numerical Simulations (DNS) of bi-disperse turbidity currents interacting with complex bottom topography in the form of a Gaussian bump. Several flow characteristics such as suspended…
The influence of high-enthalpy effects on hypersonic turbulent boundary layers is investigated by means of direct numerical simulations (DNS). A quasi-adiabatic flat-plate air flow at free-stream Mach number equal to 10 is simulated up to…
In many engineering and industrial applications, the investigation of rotating turbulent flow is of great interest. In rotor-stator cavities, the centrifugal and Coriolis forces have a strong influence on the turbulence by producing a…
The success of recurrent neural networks (RNNs) has been demonstrated in many applications related to turbulence, including flow control, optimization, turbulent features reproduction as well as turbulence prediction and modeling. With this…
The flow field generated by a transom stern hull form is a complex, broad-banded, three-dimensional system marked by a large breaking wave. This unsteady multiphase turbulent flow feature is difficult to study experimentally and simulate…
We introduce a closure model for wall-modeled large-eddy simulation (WMLES), referred to as the Building-block Flow Model (BFM). The foundation of the model rests on the premise that a finite collection of simple flows encapsulates the…
Solving the Reynolds-averaged Navier-Stokes equations (RANS) closed with an eddy viscosity computed through a turbulence model is still the leading approach for Computational Fluid Dynamics simulations. Unfortunately, universal models with…