Related papers: Fluid drag reduction by magnetic confinement
Experiments are presented that demonstrate how liquid-infused surfaces can reduce turbulent drag significantly in Taylor-Couette flow. The test liquid was water, and the test surface was composed of square microscopic grooves measuring 100…
A turbulent pipe flow experiment was conducted where the surface of the pipe was oscillated azimuthally over a wide range of frequencies, amplitudes and Reynolds number. The drag was reduced by as much as 30\%. Past work has suggested that…
Inspired by the lotus effect, many studies in the last decade have focused on micro- and nano-patterned surfaces. They revealed that patterns at the micro-scale combined with high contact angles can significantly reduce skin drag. However,…
Drag reduction by polymers in turbulent flows raises an apparent contradiction: the stretching of the polymers must increase the viscosity, so why is the drag reduced? A recent theory proposed that drag reduction in agreement with…
Viscous dissipation causes significant energy losses in fluid flows; in ducts, laminar flows provide the minimum resistance to the motion, whereas turbulent currents substantially increase the friction at the wall and the energy requirement…
In most settings, from international pipelines to home water supplies, the drag caused by turbulence raises pumping costs many times higher than if the flow were laminar. Drag reduction has therefore long been an aim of high priority. In…
The changes of a turbulent channel flow subjected to oscillations of wall flush-mounted rigid discs are studied by means of direct numerical simulations. The Reynolds number is $R_\tau$=$180$, based on the friction velocity of the…
Ferrofluids kept in place by permanent magnet quadrupoles can act as liquid walls to surround a second non-magnetic inside, resulting in a liquid fluidic channel with diameter size ranging from mm down to less than 10 micrometer. Micro…
We investigate the effect of microbubbles on Taylor-Couette flow by means of direct numerical simulations. We employ an Eulerian-Lagrangian approach with a gas-fluid coupling based on the point-force approximation. Added mass, drag, lift,…
The flow of fluids in channels, pipes or ducts, as in any other wall-bounded flow (like water along the hulls of ships or air on airplanes) is hindered by a drag, which increases many-folds when the fluid flow turns from laminar to…
Drag reduction by microbubbles is a promising engineering method for improving ship performance. A fundamental theory of the phenomenon is lacking however, making actual design quite uphazard. We offer here a theory of drag reduction by…
The present study tests the efficacy of the well-known viscous drag reduction strategy of imposing spanwise wall oscillations to reduce pressure drag contributions in a transitional- and fully-rough turbulent wall flow. This is achieved by…
We study the van der Waals frictional drag force induced by liquid flow in low-dimensional systems (2D and 1D electron systems, and 2D and 1D channels with liquid). We find that for both 1D and 2D systems, the frictional drag force induced…
We consider a fluid dynamo model generated by the flow on both sides of a moving layer. The magnetic permeability of the layer is larger than that of the flow. We show that there exists an optimum value of magnetic permeability for which…
We explore the ability of anisotropic permeable substrates to reduce turbulent skin-friction, studying the influence that these substrates have on the overlying turbulence. For this, we perform DNSs of channel flows bounded by permeable…
The lid-driven cavity flow is a well-known benchmark problem for the validation of new numerical methods and techniques. In experimental and numerical studies with viscoelastic fluids in such lid-driven flows, purely-elastic instabilities…
Injection of dilute polymer in a turbulent flow suppresses frictional drag. This challenging and technologically important problem remains primarily unresolved due to the complex nature of the flow. An important factor in the drag reduction…
We examine the fluid flow forced by precession of a rotating cylindrical container using numerical simulations and experimental flow measurements with ultrasonic Doppler velocimetry (UDV). The analysis is based on the decomposition of the…
In this article, we construct a novel 1D-model of microfluidic laminar flows in tapered circular and rectangular channels assuming the flow in channels fully developed. In the model, we take into account the inertance and dynamic pressure…
We study suspensions of oblate rigid particles in a viscous fluid for different values of the particle volume fractions. Direct numerical simulations have been performed using a direct-forcing immersed boundary method to account for the…