Related papers: On the nonlinearity of a tuning fork
In this letter, we study a nonlinear interferometric setup based on diffraction rather than beam combining. It consists of a nonlinear analogue of Young's double-slit experiment where a nonlinear material is placed exactly after one of the…
We have performed an experimental characterization of the dynamics of oscillating quartz tuning forks which are being increasingly used in scanning probe microscopy as force sensors. We show that tuning forks can be described as a system of…
Nonlinear damping plays a significant role in several area of physics and it is becoming increasingly important to understand its underlying mechanism. However, microscopic origin of nonlinear damping is still a debatable topic. Here, we…
We consider a nanomechanical analogue of a nonlinear interferometer, consisting of two parallel, flexural nanomechanical resonators, each with an intrinsic Duffing nonlinearity and with a switchable beamsplitter-like coupling between them.…
In this paper we present mathematical and physical models to be used in the analysis of the problem of intonation of musical instruments such as guitars, mandolins and the like, i.e., we study how to improve the tuning on these instruments.…
Photodetector nonlinearity, the main limiting factor in terms of optical power in the detection chain, is corrected to improve the signal-to-noise ratio of a short-time measurement in dual-comb spectroscopy. An iterative correction…
We study nonlinear interferometry applied to a measurement of atomic spin and demonstrate a sensitivity that cannot be achieved by any linear-optical measurement with the same experimental resources. We use alignment-to-orientation…
Precise measurement of the angular deviation of an object is a common task in science and technology. Many methods use light for this purpose. Some of these exploit interference effects to achieve technological advantages, such as…
Detector nonlinearity is an important factor limiting the maximal power and hence the signal-to-noise ratio (SNR) in dual-comb interferometry. To increase the SNR without overwhelming averaging time, specific experimental conditions must be…
We present a theoretical model and numerical optimization of double Bragg diffraction, a widely used technique in atom interferometry. We derive an effective two-level-system Hamiltonian based on the Magnus expansion in the so-called…
Quartz tuning forks are high-quality mechanical oscillators widely used in low temperature physics as viscometers, thermometers and pressure sensors. We demonstrate that a fork placed in liquid helium near the surface of solid helium is…
Nonlinearity in many systems is heavily dependent on component variation and environmental factors such as temperature. This is often overcome by keeping signals close enough to the device's operating point that it appears approximately…
This study describes a unique optical approach for the noncontact measurement of linear and angular displacement. Compared to previous methods, the sensor system here based on the dual-beam phase-modulated feedback interferometry provides…
We describe here the implementation of an interferometer-based microwave impedance microscope on a home-built tuning-fork based scanning probe microscope (SPM). Tuning-fork based SPMs, requiring only two electrical contacts for…
Piezoelectric quartz tuning forks have been employed as the force sensor in a dynamic mode scanning force microscope operating at temperatures down to 1.7 K at He-gas pressures of typically 5 mbar. An electrochemically etched tungsten tip…
Nonlinear optical frequency conversion, where optical fields interact with a nonlinear medium to generate new frequencies, is a key phenomenon in modern photonic systems. However, a major challenge with these techniques lies in the…
Both longitudinal and transverse coupling impedance for some critical components need to be measured for accelerator design. The twin wires method is widely used to measure longitudinal and transverse impedance on the bench. A mode error is…
In this work, we show that a recently proposed method for experimental nonlinear modal analysis based on the extended periodic motion concept is well suited to extract modal properties for strongly nonlinear systems (i.e. in the presence of…
The torsion pendulum is a prevailing instrument for measuring small forces acting on a solid body or those between solid bodies. While it offers powerful advantages, the measurement precision suffers from thermal noises of the suspending…
Tuning forks are very popular experimental tools widely applied in low and ultra low temperature physics as mechanical resonators and cantilevers in the study of quantum liquids, STM and AFM techniques, etc. As an added benefit, these forks…